Can I use Linksys WRT160N as a repeater?

Can I use Linksys WRT160N as a repeater?

Yes, you can use your second WRT and set it up as second access point for your network. First, unplug the second WRT from your network and wire a computer into one of its LAN ports. disable the DHCP server. Save settings.

How do I setup my Linksys WRT610N wireless router?

Connect the computer to any of the numbered ports on the router….

1. Access the router’s web-based setup page.
2. On the web-based setup page, click Administration.
3. Select Disabled under Upnp.
4. Click .
5. Click the Setup tab.
6. On Internet Connection Type, select Automatic Configuration – DHCP from the drop-down menu.

How do I setup a Linksys wireless router as an access point?

Connecting an access point to a Linksys wireless router

1. Open the access point’s web-based setup page by entering the default IP Address “192.168.
2. On the web-based setup page, click on Wireless.
3. Enter the Network Name (SSID).
4. Click Wireless Security and select your desired Security Mode.

How do I setup a Linksys access point?

Configuring an Access Point as a wireless repeater

1. Access the router’s web-based setup page.
2. When the router’s web-based setup page opens, click Status then click Wireless.
3. Take note of the MAC Address.
4. Connect a computer to the access point.
5. Assign a static IP address on the computer.

What is the best configuration for a wrt160 router?

The most reasonable configuration, in my opinion, was to give the WRT160 a fixed IP of 192.168.2.99, turn the DHCP of the wireless access point off, and use 192.168.2.1 (Belkin WiFi) as the gateway & dns servers. I have a similar set up in my house where I set up a wireless router with static IP and DHCP disabled to act as an access point.

What is Linksys WRT160N used for?

HARDWARE INFORMATION. The Linksys WRT160N Wireless-N Broadband Router is a three-in-one device. It acts as a wireless access point which lets you connect your wireless computers and devices to it without using wires. It also serves as a built-in 4-port full-duplex 10/100 switch to connect your wired devices to it using Ethernet cables.

Does the WRT160N allow VPN tunnels to pass through the router?

  Does the Linksys WRT160N allow Virtual Private Network (VPN) tunnels using IPSec, L2TP, or PPTP protocols to pass-through the router? Yes. 6.   How many Access Policies can I set up on Internet Access Policy?

How to configure a wireless router?

Here are some steps to help you configure it. Connect to the router. Use an ethernet cable, and plug your computer into the router. Then turn on the router and connect to it using a web browser such as Internet Explorer or Firefox. This is done by typing the IP address of the router.