How do you fasten a tie step by step?

How do you fasten a tie step by step?

THE HOLY TRINITY OF TIE KNOTS

1. Place the tie around the neck.
2. Cross the wide end over the narrow end.
3. Loop the wide end back underneath the narrow end.
4. Bring the wide end over the narrow end once more.
5. You’ll have to loop now to knot the tie with.
6. Pass the wide end down through the loop in front.

What are the six steps to tie a tie?

Follow These Steps

1. Place tie around your neck.
2. Cross the wide end over the thinner end.
3. Run wide end under tie and pull it across again.
4. Pull the wide end through the center.
5. Loop through the knot.
6. Tighten the knot.

What are the ways to tie a tie?

1. Four In Hand Knot

1. Loop the tie around your collar.
2. Cross the thick end in front of the thin end.
3. Wrap the thick end around behind the thin end and cross horizontally from right to left.
4. Bring the thick end horizontally across the front of the knot from right to left.

How do you tie a tie with two ends?

Insert the wide end through the front knot. Place the wide end through the horizontal knot at the front of the tie. Pull it through. Tighten the knot. Hold the base of the front knot and squeeze gently from the sides. Slowly pull the wide end of the tie to bring the knot closer to the neck. Place the tie upside down around your collar.

How do you tie a tie with a Pratt knot?

To begin tying the Pratt knot, raise the shirt collar and drape the tie wrong side up with the wide end hanging on the right side roughly 12 inches lower than the narrow end. Cross the wide part of the tie under the narrow part. Bring the wide end up and loop it down through the opening at the neck and tighten.

How do you tie a full Windsor knot?

1 To begin tying the full Windsor knot, raise the shirt collar and drape the tie around the neck, so the wide end is on the right side and extends about 2 Cross the wide part of the tie over the narrow part. 3 Pull the wide end up through the opening at the neck, then down.

How do you tie an Eldredge knot?

How to Tie an Eldredge Knot. Take it across the front to the right and through the loop created in the previous step. Tighten the knot by pulling the narrow end to the right. Bring the end straight up and through the neck loop to the right of the knot. Again, bring it up, over the knot to the left of the knot.