Table of Contents
How do you get the Amana washer to drain?
Place a broad, flat container beneath the drain pump filter to collect the drain water. Release the black hose from the hose clip, remove the plug, and drain the hose into the container. Empty the container. Repeat this procedure if necessary until all the water has drained.
Why is my washer washing but not draining?
Your washer may have a clogged drain hose or the pump may be broken. A broken lid switch or belt could also be the culprit. It may even be something as simple as the hose being jammed. Whatever the reason, the water will need to be drained from the washing machine before any work or diagnosis can be done.
Does my Amana washing machine have a filter?
Does my Amana top load washer have a filter? If it’s a top load Non-HE washer, then yes it will have a lint filter. If it’s a High-Efficiency washer, then it won’t have a lint filter. The High-Efficiency variants make use of a self-cleaning pump filter to remove lint.
Where is the lint trap in my Amana washing machine?
Where Is the Lint Trap on a Washing Machine?
- Along the top rim of the washer drum: Slide your fingers around the top of the washing basin, and you may run into a screen, which you can pull out to remove lint.
- Inside the center agitator: If you have a top-loading washer, inspect the center agitator.
Where is the lint filter on an Amana washing machine?
Where is the Filter on a Washing Machine?
- In the front of the unit behind a small hatch.
- At the end of the drainage hose.
- Under the cover of your center agitator.
- Along the top rim of the drum of your washing machine.
How do you clear the codes on an Amana washing machine?
To remove the code, press pause or cancel button twice and the power button once. If the code is still displayed, unplug the washer or disconnect the power for one minute. Items were detected in the washer during the Clean Washer cycle. Remove items from the drum and restart the Clean Washer cycle.
Why is my Amana dishwasher not draining?
Examination Prep. Before you do anything,it’s always good to be safe.
Why is my Amana washer not working?
If the user control and display board has power, but it isn’t working, replace it. The line fuse blows if the washer circuits are overloaded. If the line fuse blows, the washer won’t start. To determine if the line fuse is at fault, use a multimeter to test it for continuity.
What are common problems with the Amana top-load washer?
Top-Load Amana Washer Locking/Unlocking Issues and Solutions Top-Load Error Code. If you have issues with the lid locking or unlocking, you may see some of the error codes. Check for Lock Interference. If the lid of the top-load is locking, you should check for lock interference with the washer’s lock striker. Clean the Lock.
Why is my Amana dryer drum not turning?
– Unplug the dryer from the electrical outlet. – Slide a putty knife under the top panel of the dryer to release the clamp. – Slowly open the top panel and secure it with a piece of rope to prevent it from falling shut. – Unplug the door switch wires. – Remove the front panel mounting screws with a screwdriver.