What does a wind Post do?
A Windpost is a structural product used in the construction of masonry walls to increase lateral stability and protect masonry panelling against horizontal forces such as wind, crowd or handrail loads. Windposts are normally constructed from mild steel, supported at the head and the foot between floor slab levels.
Do I need a wind post?
Wind posts would be used for example in the cavities of the walls used on either side of bi-fold or concertina type doors so that the entire end of the building can be glazed without the need for wide masonry returns on either side of the doors. This enables a much wider opening to be achieved.
Where do Windposts go?
Windposts can be installed into either the inner leaf of blockwork or into the cavity leaving the blockwork undisturbed. They are designed to suit specific applications and are supplied complete with end connections and ties.
What is a masonry return?
Masonry Return Joist Hanger is designed for similar applications and installation as the standard Masonry Joist Hanger. The return adds additional lateral support by wrapping around the back of the masonry or timber. The hanger has a 25mm drop on the return flange as standard.
Why do I need Windposts?
A windpost is a structural item used in the design and construction of masonry walls to increase lateral wall stability and protect them against damage from horizontal forces imposed by wind pressure, crowd or handrail loads.
What is an Ancon Windpost?
Ancon Windposts are designed to span vertically between floors to provide lateral support for panels of brickwork. Windposts can be installed into either the inner leaf of blockwork or into the cavity leaving the blockwork undisturbed.
What is the filling in between bricks called?
In masonry, mortar joints are the spaces between bricks, concrete blocks, or glass blocks, that are filled with mortar or grout. If the surface of the masonry remains unplastered, the joints contribute significantly to the appearance of the masonry.
What does 3rd lift brickwork mean?
2 Answers from MyBuilder Bricklayers 2nd lift is up to joist height remember this includes the installation of the lintels and cavity trays. 3rd lift is from joist to Window cill height ( Raise scaffold ) 4th lift up to wall plate this includes the installation of the lintels & bedding of wall plate (raise scaffold)
What are wall ties made of?
These days, wall ties are predominantly manufactured from stainless steel which is now readily available commercially and withstands corrosion from water and cement without requiring additional protection.
What is half a brick called?
When a brick is cut along its length, making it two equal halves then it is called queen closer. Thus a queen closer is a broken brick portion whose width is half as wide as the original brick. This is also called as queen closer half.
What is Arris in brick?
Arris. Definition: The sharp edge between two adjacent surfaces of a brick.
What is a hog in the wall?
“A hog in the wall” is a tongue in cheek term of foreboding that something unpleasant is about to happen. The term was in common use on the plains of eastern Colorado/Nebraska pre and post dust bowl.
What is a butterfly tie in construction?
Traditional galvanised wire Butterfly Ties. Twist central is used to prevent moisture travelling across cavity (twist must be placed down the cavity). Used in general for house & building walls in the building and construction industry.
What is Flemish bond in brickwork?
A flemish bond is a brick construction pattern that consists of alternate stretchers and headers for each course.
What causes white marks on bricks?
A: The white spots are efflorescence, a crust that develops when water laden with mineral salts moves through the bricks and evaporates, leaving salt crystals behind. It’s ugly but usually doesn’t cause damage, so you can take your time figuring out a solution.