What is Cisco C3KX nm 10G?
The C3KX-NM-10G Network Module from Cisco is a network module for uplink ports compatible with the Cisco 3750-X and 3560-X series switches. The module has four slots, two can be used to support 1-GB SFP modules, while the other two slots support both 1-GB SFP and 10 GB SFP+ modules.
How do I wipe a Cisco switch?
The Easy Way! Hold the “mode” button on the front of the switch for 10 seconds. The lights will blink then go solid – the switch completely wipes all configuration and then reboots.
What is reload in Cisco switch?
The reload command halts the system. If the system is set to restart on error, it reboots itself. Use the reload command after configuration information is entered into a file and saved to the startup configuration.
How do I remove a VLAN dat from a Cisco switch?
Deleting the VLAN Database from a Cisco Switch
- 1) Deleting the switch configuration. This is the easy part.
- Switch#erase startup-config.
- Switch#reload.
- 2) Deleting the switch Vlans.
- Switch#show vlan brief.
- Switch#show flash:
- Switch#delete vlan.dat.
- Switch#sh flash.
How do I enable GUI on a Cisco switch?
Enabling Web and Secure Web Modes
- Choose Configuration > Switch > Management > Protocol Management > HTTP-HTTPS.
- To enable web mode, which allows users to access the switch GUI using “http://ip-address,” choose Enabled from the HTTP Access drop-down list.
What is the difference between L2 VLAN and L3 VLAN?
I answered them, Layer 2 VLAN is a single broadcast domain. It works on layer 2 (Datalink Layer). They can communicate only within it. And L3 VLAN is an Interface, that works on Network Layer.
How do you power cycle a Cisco switch?
Disconnect all Ethernet cables from the switch. Using a pin, press and hold the Reset button on the switch for 15 to 20 seconds.
What are two characteristics of RAM on a Cisco device?
What are two characteristics of RAM on a Cisco device? (Choose…
- RAM provides nonvolatile storage.
- The configuration that is actively running on the device is stored in RAM.
- The contents of RAM are lost during a power cycle.
- RAM is a component in Cisco switches but not in Cisco routers.