Table of Contents
Does a Jeep TJ have an OBD port?
Here is the business end of your Jeep that the OBDII cable will attach to. On my ’98 TJ, the connector is located in the vicinity of your left knew, right underneath the dash. What is this? With the cable connected to the ODBII port, connect the 9 pin serial cable to your laptop and you are ready to go.
What is the obd2 port connected to?
OBD-II is an onboard computer that monitors emissions, mileage, speed, and other data about your car. It’s connected to the Check Engine light, which illuminates when the computer detects a problem. The OBD-II onboard computer features a 16-pin port under the driver’s side dash.
Where do I connect diagnostic tool?
Typically, it is somewhere near the steering wheel, underneath the dashboard. A few cars have the port on the passenger side or somewhere around the center console. Check your car’s user manual for specific details. Turn the car off before plugging the automotive scan tool into the OBD-II port.
Where do you plug in engine code reader Jeep Wrangler?
Since the implementation of the OBD standard, each vehicle has a standard 16-pin connector, as described on our OBD presentation page. The norm states that the port must be located inside the vehicle passenger compartment.
Does Jeep Grand Cherokee have OBD port?
OBD-II equipped vehicles have a connector located in the passenger compartment, usually accessible from the driver’s seat (under the dash above the hood release lever in the Grand Cherokee WJ).
For what connection is terminal 16 of the OBD-II?
diagnostic link connector
The diagnostic link connector (DLC) on OBD II equipped vehicles is a standardized 16 pin diagnostic connector used to interface an OBD II compliant scan tool with the PCM allowing access to on-board diagnostics and live data streams.
Are all obd2 connectors the same?
All OBD-II pinouts use the same connector, but different pins are used with the exception of pin 4 (battery ground) and pin 16 (battery positive).
What does check gauges mean on 2004 Jeep Grand Cherokee?
The “Check Gauges” light means just that. Look at all the gauges while engine is running and see which one is not in it’s normal range. Gas gauge doesn’t matter. Temperature gauge should be about 195 degrees, voltage should be about 14 volts, and oil pressure at idle is about 40 psi.
Where is the OBD connector on a Jeep Grand Cherokee?
OBD connector location for Jeep Grand Cherokee WJ (1998 – 2005) You will find below several pictures which will help you find your OBD connector in your car. The OBD socket is located under the steering wheel on the left. Go to the OBD2. scanner for JEEP. The OBD2 plug is above the hood lever. Here is the OBD2 diagnostic port.
Do I have an OBD2 port on my car?
To determine which one you have, if your vehicle was built and sold in the US after January 1st, 1996 you will have an OBD 2 port. This service will allow you to find the OBD2 port location.
Where is the EOBD port on a car?
The norm states that the port must be located inside the vehicle passenger compartment. Depending on the make and model, it may or may not be easy to locate. To diagnose your vehicle yourself, download our EOBD-Facile car diagnostic software.
How many pins does the OBD port have?
Since the implementation of the OBD standard, each vehicle has a standard 16-pin connector, as described on our OBD presentation page. The norm states that the port must be located inside the vehicle passenger compartment.