How does a Hayward valve work?
Water from the pump is fed into the bottom of the filter tank, pushed up through the sand to release the trapped dirt particles and purged out a waste line connected to a port at the top of the Filter Tank. The Hayward Slide Valve is used to reverse the flow of water inside the Filter Tank.
How do I identify a Hayward multiport valve?
The easiest way to identify your multiport valve is to find a manufacturers part code, this is normally found along the front face of the multiport valve. Once you have identified this number we can then use it and match it up to a valve that suits your pools filtration system.
What setting should I clean my pool?
To begin vacuuming your pool:
- If you have a sand filter and are vacuuming to waste, set filter to “waste” option.
- Otherwise, leave setting on “filter” and turn pump on to begin vacuuming.
- Vacuum your pool just as you would vacuum your living room, picking up debris or algae as you go.
Why is sand coming out when I backwash?
Your pump may be too large or the sand level too high in the filter. When the filter is backwashing the water flow can cause the sand to rise high enough and overflow into the standpipe, which will allow the sand back into the pool.
Why is water coming out of my backwash?
Sand or dirt build-up around the multiport valve, diverter, or spider (aka spoke) gasket can cause water to leak out of the backwash line when the pool is set on “filter“. This is very common with sand filters and Diatomaceous Earth (DE) filters.
Should I run my pool pump on high or low?
No matter what size pump you are using, running it at lower speeds saves energy – and money. For example, you could run your variable or two speed pump twice as long as you normally would on its higher speeds and still save money.
Why would you use recirculate on pool filter?
Recirculate – This setting is used to troubleshoot problems with the filter sand and is especially useful if you are battling an algae bloom. The water will circulate in the pool normally, but will bypass the filter sand.
What pressure should my pool sand filter be at?
9-10 psi
Your filter may be clean and normal at 9-10 psi, but your neighbor’s filter gauge could run higher, and be clean at 15-16 psi. Some systems with very low resistance can run very low pressures, barely registering, while other filter systems can run quite high, pushing 30 psi when the filter becomes dirty.
What is a haywhayward Vari-Flo valve?
Hayward 1 1/2″ 6-posiotn Vari-Flo- Model SP0710XR50 HaywHayward® SP0710XR50Vari-Flo valve is a six position valve for use with Pro Grid, Micro-Clear Hayward DE filters.
What is the sp0710xr50 Vari-flovalve valve?
HaywHayward® SP0710XR50Vari-Flo valve is a six position valve for use with Pro Grid, Micro-Clear Hayward DE filters. The Vari-Flovalve has the FILTER, and BACKWASH, WASTE, RECIRCULATE, RINSE, CLOSED, positionS
How much does a Hayward backwash valve cost?
Hayward® SP0710XR50Vari-Flo valve Hayward Filter Backwash Valves Hayward 1 1/2″ Vari-Flo- Model SP0710XR50 $89 Hayward 1 1/2″ 6-posiotn Vari-Flo- Model SP0710XR50
What does the side mount valve do on a Hayward filter?
This is the Hayward side mount valve used on the Micro-Clear and Pro-Grid Series of DE filters. Waste – By-passes the filter for draining or lowering pool water level and for vacuuming heavy debris directly to waste line.