What is the current ATA 103?
ATA Specification 103 provides guidance for the safe storage and distribution of jet fuel at airports as currently practiced in the commercial aviation industry. It also includes forms that can be used to record performance of tests and inspections. The 2019.1 revision includes extensive revisions to the document.
What is the proper color coding for jet fuel?
Green: AvGas 100 (100/130 Octane) Blue: AvGas 100LL (100/130 Octane). This was formulated as a replacement for AvGas 100, with half the lead, thus the name 100LL for Low Lead. Red: AvGas 80 (80/87 Octane)
What is an acceptable Millipore test rating?
Gravimetric limits of 1.0 mg per liter (or 3.785 mg per gallon) maximum apply. If this gravimetric limit is met, fuel is acceptable and the Membrane (or Millipore™) Color rating greater than 4 wet (or 3 dry) on a one (1) gallon sample may be waived.
What octane level is jet fuel?
The octane ratings of AVGAS, a gasoline-based fuel, are usually either 91 or 100 (lean mixture) and 96 or 130 (rich mixture). The octane rating of jet fuel is much lower, around 15 – this is much more like automotive diesel and thus much more resistant to detonating due to sparks or compression.
What is an acceptable membrane color filtration Millipore test rating?
What is the correct FSII to fuel ratio?
FSII is an agent that is mixed with jet fuel as it is pumped into the aircraft. The mixture of FSII must be between 0.10% and 0.15% by volume for the additive to work correctly, and the FSII must be distributed evenly throughout the fuel.
Can a jet run on avgas?
While most commercial turbine engines can run on avgas within certain limitations, piston engines cannot run on jet fuel. With its extremely high flash point, jet fuel, in essence, creates a detonation that will cause a gas-based engine to misfire and eventually fail.
What is Millipore value?
The Millipore value provides a measure to calculate the amount of dirt on the component or the complete engine. Therefore, OEMs decide on a Millipore value for their entire engine assembly. Based on their Millipore value, they provide these values for every engine component.
Is standard for Millipore test?
Pioneering the use of membrane technology across hundreds of applications, the Millipore Corporation became instrumental in defining standards for the testing of compounds, and after many years on continued use of their game changing filtration technology using membranes, the Millipore name became synonymous with …
What does ATA Spec 103 stand for?
ATA Specification 103 Copyright © 2006 Air Transport Association of America, Inc. All rights reserved. Output Page: 1 Spec 103 Information ATA Specification 103 Standard for Jet Fuel Quality Control at Airports Revision 2006.1
Does ATA 103 apply to airlines?
ATA Specification 103 does not, in itself, impose any performance obligations on any airline, fuel supplier, fuel storage facility, fuel transporter, or any other entity. Its provisions become effective only to the extent they are adopted by an airline and incorporated into its operating manual.
Which section of ATA specification 103 should an airport facility operator follow?
Airport facility operator should follow the “TRANSPORT TRUCK DELIVERIES” section for guidance procedures. 5. Marine Vessel Deliveries Airport facility operator should follow the “PIPELINE DELIVERIES” section for guidance procedures. ATA Specification 103 Copyright © 2006 Air Transport Association of America, Inc. All rights reserved.
Can I photocopy the ATA 103?
No part of this document may be reproduced or transmitted by any means, electronic or mechanical, including photocopying and recording, or by any information storage or retrieval system, except as may be expressly permitted in writing by the publisher. ATA Specification 103 Copyright © 2006 Air Transport Association of America, Inc.