Table of Contents
How do I lock my dbx pa2?
– Rotating the wheel to select either Lock, Unlock or Filter Unlocked the system. – Pressing will unlock the system if it were locked or it will lock the system if it were unlocked.
How do I reset my pa2 drive rack?
Factory Reset (Hard Reset) – Hold STORE button during power up until the display will shows ‘FACTORY RESET’. Then release the Store button. Now Press the WIZARD button to do the factory reset. Pressing the STORE button will abort the factory reset.
Can you use any mic as an RTA mic?
Getting an accurate RTA reading requires an omnidirectional microphone with an extended flat frequency response from 20 Hz to 20 kHz. There are a number of manufacturers offering mics especially designed for RTA use. It is not recommended to use a microphone meant for live sound or other general, non-RTA use.
What is a reference microphone?
A microphone designed to deliver flat, uncolored response. While reference microphones can be used for recording or sound reinforcement, they are generally intended for use with audio analysis equipment for measuring the acoustical characteristics of a room. Most reference mics feature omnidirectional polar patterns.
How do I set the input delay on my PA2?
instrument furthest back on stage (usually the drums) and the main speakers then enter this distance into the input delay module (the PA2 allows you to enter the delay time setting in feet, meters, or milliseconds – no calculation required). Don’t
What is the dbx Type IV™ conversion system?
The dbx Type IV™ conversion system built into the PA2 will clamp down on excessively loud input signals and prevent the A/D converters from clipping. If you’re lighting these LEDs, you will need to reduce the output level of your mixer.
How does dbx’s Advanced feedback suppression work?
Fortunately, dbx engineers have revisited their already-stellar Advanced Feedback Suppression algorithm and made it work even better. The DriveRack PA2 listens for and anticipates feedback and adjusts speaker output automatically before it even has a chance, while never altering your sound.
Why won’t my PA2 pass audio through the mid and low outputs?
When the PA2 is configured for this type of application using the Setup Wizard, only the HIGH outputs will be enabled; the MID and LOW outputs will be disabled and will not pass audio. Application Notes: • Make sure your mixer and amplifiers (or powered speakers) are turned off before making connections.