Does trifecta tune remove the speed limiter?
– Typical tune loading can take approximately 25 minutes. Can I turn off or raise the speed limiter? – No, the EZ Flash program will not allow for that change but Trifecta will change the speed limiter to the maximum speed that your tires are rated too.
Is the trifecta tune worth it?
This is the first time I genuinely enjoy daily driving the car even more. I feel that not only did Trifecta tune this car for more power. But they completely redid the engine mapping to make this truck more fun to drive. I am thrilled with my purchase, and I highly recommend it to anyone who is considering one.
How do you Datalog a trifecta?
You go on ezflash and hit program vehicle, datalog vehicle (while connected to the car). Let it idle for a minute or two, do a couple wide open throttle runs and just some regular driving. After 15 minutes you can end it and it will save the log. You then upload the log and they will send you an update.
How much is a trifecta tune?
TRIFECTA Elite service is now available via WOT-Tuning for $398 retail instead of $588. We are also eliminating the Advantage+ product tier. There is no change to the TRIFECTA Advantage calibration pricing.
What should I look for when logging into a car?
Some of the most important parameters to data log for engine performance and reliability are fuel pressure, oil pressure, air/fuel, exhaust gas temperature, knock sensor, exhaust back pressure and oil temperature.
How much would a custom tune cost?
Money equates to time. Each setup is different, and also depending on what type of system is being used (piggy back, chip, stand-alone, supercharged, naturally aspirated, street or race only, etc) tune costs can range from $250 to $1500. Don’t be afraid to spend money on a good tune.
Is a custom tune better?
As we say, It’s important to note that “custom software” does not necessarily equal quality tuning. Out of the box tunes that are already professionally tuned are usually a better product.
How do I read Ecutek logs?
To view your log, simply open ProECU and to to file, then Open Log File. Once your log is loaded there are many ways to view this. The Time Graph method shows all the parameters laid out over time. This is very useful to see a few changes happening at one time.