Where is the model number on a superior fireplace?
The model and serial numbers are located on a “rating plate,” which is a metal plate that’s usually permanently affixed to the fireplace, insert or stove. In gas fireplaces, the rating plate is found in the controls area.
What is thermopile on gas fireplace?
The thermopile, on the other hand, opens up the gas valve when the fireplaces are turned on. The Thermocouple and the Thermopile carry out a similar function of converting heat to electricity, but the thermopile generates more electrical current compared to the thermocouple.
Can you sand a thermopile?
What is this? Much like cleaning the thermocouple, you might want to start by cleaning your thermopile. Lightly sand away the carbon deposit until it looks clean again.
How can I tell what brand my fireplace is?
To know for sure, you will have to look for the nameplate that lists the manufacturer, model, and serial number. This nameplate is usually located on the right hand facing of the fireplace just behind the screen. It could also be underneath the firebox if there is a grill at the bottom that flips down.
How much does a thermopile cost?
24″ Thermopile
| Was: | $16.99 Details |
|---|---|
| Price: | $15.48 |
| You Save: | $1.51 (9%) |
How do I know if I have a thermopile or thermocouple?
The main difference between Thermocouple and Thermopile is their method of measurement. The thermocouple is a thermoelectric instrument, while the thermopile is an instrument that modifies thermal energy into electrical output.
How many millivolts does a good thermopile produce?
A healthy thermopile in an open circuit test will read between 650 to 850 millivolts or somewhere in between. If the open-circuit test reads below 400 millivolts, then the thermopile likely requires service or replacement.
How much is an antique wood burning stove worth?
In general, the condition, size, design, and rarity will determine the value of the stove. Most are in the $100 to $500 range, though some can go for several thousands of dollars.
How do I know if my gas fireplace is vented or ventless?
A vented fireplace has attractive yellow and orange flames that lick upward around the sides of the ceramic logs. An unvented fireplace, by contrast, has much less striking flames. These flames tend to be smaller and bluer. As a result, an unvented gas fireplace won’t create quite the same illusion as a vented one.
How do you fix a thermopile?
Replacing a Thermopile
- Turn off the Gas Supply.
- Disconnect the Wires.
- Remove the Manifold Door.
- Remove the Pilot Assembly and Thermopile Wire.
- Place the New Thermopile Wire.
- Feed the Wires Through the Manifold Door.
- Install the Manifold Component Block.
- Reconnect the Thermal Switch Wiring.
Can you replace a thermopile with a thermocouple?
Thermocouples, however, do not perform their function the same way as thermopiles do. You can’t use thermopiles and thermocouples interchangeably. If you need to replace a temperature sensor like a thermocouple or thermopile, make sure that the component you purchase is the correct one.