How do I reset my interlogix XT keypad?

How do I reset my interlogix XT keypad?

You can reset an Interlogix Simon XT to factory defaults by first powering down the panel completely. Then hold down the four top buttons on the panel while the system is being powered back on. If successful, the Simon XT will reboot with its factory default settings fully restored.

How do I program my sensors Simon XT?

Simon XT – Motion Detector Programming

1. Press or until SYSTEM PROGRAMMING then press.
2. Press or until SENSORS then press.
3. Press again to place panel into learn mode.
4. Simon XT beeps and “Grp” flashes, press.
5. Sensor name flashes, press or to scroll names then press to select.
6. When finished press.

How do I silence low battery alarm Simon XT?

Press the STATUS button or arm/disarm the system to silence the beeps.

How do I program my Simon XT key fob?

You can program a key fob to an Interlogix Simon XT by accessing the System Programming Menu. Put the system in its learn mode and then press and hold the top two buttons on the device. Once the key fob has been learned in, you can adjust its settings and configurations as needed.

How do I change the battery in my Simon XT alarm?

Simon XT – Replacing Panel Battery

1. Go to your keypad and press down on the two tabs on the top of the keypad.
2. Cover will swing down revealing battery inside.
3. Take new battery and replace leads pairing black with black and red with red.
4. Place batter back into the panel, leads down.

How do I change my Simon XT code?

Simon XTi – Change Master Code

1. Press bottom right GEAR icon then press DOWN ARROW several times.
2. Press ENTER button by Programming then enter Master Code then press OK.
3. Press ACCESS CODES then press box by Master Code.
4. Enter new Master Code then press SAVE then CLOSE button to exit User.

How do you program a key fob?

To program your keyless-entry remote, press and hold the “LOCK” and “UNLOCK” buttons on the key fob simultaneously until the locks cycle once more. This could take up to 30 seconds, so be patient. Once you hear the locks cycle, your key fob should be programmed to your GM.