Table of Contents
How do you prime a sea strainer?
To prime my sea strainer, after cleaning it, I just leave it slightly loose and open the seacock and let the water fill until all the air is out and it is full of water. I then tighten it, mop up any drips and check for leaks.
What do sea strainers do?
Sea strainers, also known as raw-water strainers, provide your boat with a layer of defense against the ocean. These strainers filter out the junk and debris from the water that your boat uses to cool its engine.
Are sea strainers necessary?
Every boat that brings aboard outside water to cool the engine, whether the raw water flows through the engine or through a heat exchanger, needs a strainer to prevent grass and other solids from reaching the pump.
How do I clean a strainer?
Spray the outside of the strainer so the water goes through the mesh and loosens the food particles. Then scrub both sides and rinse again.” If the sponge just isn’t doing the trick, a coarse brush (a stainless-steel brush or old toothbrush will work) can help get those stubborn bits out.
How do I prime my boat AC?
To prime the pump I close the thru hull, attach a piece of clear hose from the galley facet to the hose barb. Open the ball valve, turn on the galley facet, hear water running out the AC discharge. Then close the ball valve, open the thruhull and turn on the AC. Faster to do it than explain it.
How do you clean brass seacocks?
Use a metal polish formulated for brass on a soft damp cloth then polish off with a clean soft cloth. They can be sealed with various clear products but if you have to clean em now & again at least you will be able to check their condition.
How do you get mold out of a mesh strainer?
Prepare a solution by mixing some baking soda with warm water and then keep the strainer immersed in it for a few hours. After that just gently brush it and wash properly.
How do you prime a marine pump?
How To Prime Your Water Pump
- Make sure the power is turned off. Never leave a pump plugged in while you’re working on it.
- Gain access to the pump system.
- Check for damage.
- Test a hose.
- Open the relief valves.
- Attach the hose.
- Turn on the water and wait for it to enter the tank.
- Turn the power on.
What is Barnacle Buster made of?
Barnacle Busters active ingredient is phosphoric acid, a common cleaning acid. (Several products in our May 2006 rust-stain remover test used phosphoric acid.)
How long does a Marine air conditioner last?
about 15-20 years
“A self-contained marine air conditioner,” he adds, “has a life expectancy of about 15-20 years, depending on how much it is used, with many older units still cooling effectively since the 1980s.” Since 1985, Power & Motoryacht has been keeping boaters in the know.
How do you clean a clogged fine mesh strainer?
How do you clean a fine mesh strainer?
Follow these steps:
- First, soak it in soapy water.
- Turn the strainer upside down and use your sink’s faucet or sprayer on the strainer to remove any loosened food particles.
- Time to give it a good scrubbing.
- Rinse with warm water.
- Air dry or dry with a soft cloth.
What is a raw water sea strainer?
What is a raw water sea strainer? For those in the learning process, a seawater strainer is simply a filter that separates debris from the seawater before the water is used to cool the engine’s sweet water system and ultimately the engine. How does a raw water sea strainer work?
How do I clean the strainer on my seacock?
With the seacock valve closed, open the seawater strainer housing (1 in the above pic, screw off type) to access the strainer basket. Some strainers require a wrench to open, be sure to keep these easily accessible. The strainer basket (3 in the above pic) should lift straight out and allow for cleaning.
What happens if you don’t maintain your sea strainer?
STRAINER RAW WATER INTAKE can only be stopped by the seacock (below waterline system) so it’s imperative the seacock is fully functional to stop leaks or carry out any maintenance. Risks of flooding or sinking a boat if seacock, hoses, and the sea strainer are not fully maintained to prevent leaks.
What is a strainer filter system?
The STRAINER FILTER BASKET is a removable system that has no moving parts but requires regular maintenance. Strainer below the waterline which has a through hull RAW WATER INTAKE always with a seacock to stop uncontrollable water ingress and enable maintenance.