How do I install a new amp in my car?
Your Step-By-Step Guide
- Step 1: Disconnect the Car Battery.
- Step 2: Mount the Amp.
- Step 3: Install the Power Wire.
- Step 4: Install the Fuse Holder.
- Step 5: Connect the Power Wire.
- Step 6: Install the Ground Wire.
- Step 7: Plug in RCA, Speaker, and Remote Turn-On Leads.
- Step 8: Turn It On.
How do I hook up my amp?
How to install the amplifier
- Step 1 — Disconnect the battery.
- Step 2 — Mount the amplifier.
- Step 3 — Install the power wire.
- Step 4 — Install the fuse holder.
- Step 5 — Connect the power wire.
- Step 6 — Ground wire: the most important connection of all.
How long does it take to install an amplifier in a car?
A car amp can be a difficult installation since you’re working with your vehicle’s electrical system, but you can finish within about 3–4 hours.
Where is the best place to install car amplifier?
A common place to fit an amp is in the trunk or luggage compartment of your car. However, if you’re driving, say, an SUV, space becomes limited and you’ll need to consider mounting the amp under, behind, or between the seats. Another consideration is that amps generate heat—hence the need for cooling fans.
Can I add an amplifier to my stock stereo?
Usually, you’ll be installing a 4-channel amplifier with speaker-level inputs. The best way to connect it to a factory system is to tap into the stereo’s speaker outputs for the amp’s input signal. Then send the amp’s outputs back to the stereo’s harness, and on to the speakers through the factory wiring.
How to install a switch to a car AMP?
To install a toggle switch in your car, you’ll need to drill a hole for the switch in your paneling and wire it in to the power supply. Make sure you disconnect all power from the device before you start to protect you from an electric shock.
How do you install an amplifier in a car?
Raise the hood on your vehicle and look to see which side your battery is located on. Disconnect the negative battery terminal.
How to install an amp and subwoofer in a car?
Subwoofers require a lot of power, so they have to be wired to both a power source, like a car’s battery, and an amplifier. After connecting them to the stereo speakers, run a separate wire to a ground source, such as an exposed metal bolt, for safety.
How to install car amplifier at home?
Car amplifiers are mostly rated at 14,4V and lower impedances (1 or 2 ohm for example) while some home amplifiers can only go as low as 4 ohms. Since you will be running it off 12V power supply (more about that in further steps) you might not get as stable power as you would in your car.