How much power does an Eberspacher heater use?
The Eberspacher S2 D2L in use As the heater powered up and boosted to maximum output, it drew about 2.5A, warming the boat rapidly. In terms of fuel consumption, the manufacturer claims the heater will use between 0.1L and 0.28L of diesel per hour, though we couldn’t easily measure this.
Why is my Eberspacher heater not working?
1. Do the fuel quantity check, if the amount of fuel is insufficient, than check the fuel pick-up pipe, fuel lines and connections, fuel filter on the pump, replace the filter or pump if necessary. 2. Check the glow pin, clean ventilation hole and replace atomizing screen.
How many amps does a diesel heater pull?
On startup, it takes approximately 10 amps of power consumption. It takes around 3 minutes to get the burner hot. After the flame is established, our diesel air heaters draw between 0.55 to 0.85 amps, making them very efficient to operate.
Which way does the fuel pump go on a diesel heater?
This is the most common of the diesel heater installation mistakes… but it’s an easy fix:
- The fuel pump should be mounted on a 15-30 degree angle to allow the air bubbles to escape.
- The muffler is mounted vertically, not on it’s side, to allow the water to drain out of the weep hole.
Are Chinese diesel heaters safe?
The brand-name heaters make much of the fact that they are very safe. For example, Webasto advertises safety features that include: Under / Over voltage cut-off. Overheat temperature sensor (in case of a blocked vent)
Do you need to vent a diesel heater?
In short: Diesel heaters need to be vented. When the combustion of diesel occurs, some gases are formed. These gases are detrimental to your health and that of those inside the caravan or automobile.
Do you need a leisure battery for diesel heater?
Will a diesel heater drain my battery? Diesel heaters only use 12v power from your leisure battery to spark the initial combustion and then to drive the small recirculating fan while the heater is running.
Are Chinese diesel heaters worth it?
However, the Chinese heaters tend to get a bad reputation for reliability, parts availability and, most importantly, safety. Chris Emmerson of CJE Caravan Repairs has seen a lot of dodgy products come through his workshop, but increasingly he is being asked to fix issues associated with cheap ducted diesel heaters.
Where is the fuse on a diesel heater?
The fuse should be located in the main cables near your battery.
How do I identify an eberspacher heater cable?
Connectors at the controller end of the loom may have been cut off and different connectors could be used so use the cable colours as the main identification. Check with the pin numbers at the Eberspacher heater end of the cable if unsure.
What are the colour codes for eberspacher wiring?
Eberspacher Wiring Colour Codes Eberspacher manuals use these codes to indicate wiring colours. Eberspacher Airtronic cable connector S1 Airtronic D2 D4 D5 D2 D4 D5 Airtronic cable connector S1 Eberspacher D1LC D3LC D5LC
What size wire do I need for eberspacher low voltage?
(Full details on Low voltage page). For a D2 / D4 Eberspacher recommend 4 mm2wires for up to 2.5m individual wire length; ie 2.5 m positive wire and 2.5 m return wire. Increase the cable size to 6 mm2up to 4 m, and 10 mm2or more for longer runs.
Can you add a 2nd eberspacher controller?
Second Eberspacher controller When installing it might be worth considering if adding a second controller will be a useful addition. Even if it is added at a later date installing the switch will be easier if it is done with the main wiring. Details on Controllers 4 page.