What are the codes for a Maytag front load washer?
Error Codes in my Maytag Front Load Washer
| Error Code | Error |
|---|---|
| Sud or Sd | There are too many suds in the washing machine. |
| F5 E2 | The door is not locking properly. |
| F7 E1 | Indicates a motor speed sensing error, |
| F8 E1 or LO FL | The washer is sensing a low flow of water. |
How do I reset my Maytag front load washer?
The easiest way to reset a Maytag washer is to disconnect the power to the washing machine for three minutes. Disconnecting the power allows the electrical charge to dissipate from the washing machine, which allows it to reset. If the reset fails, unplug the washer again, this time leaving it unplugged for ten minutes.
How do you clear a washing machine code?
Rotate your dial until you have the following three lights illuminated: RINSE, WASH, and STOP. Then turn off your washer and unplug it for ten seconds. When you turn it back on it should be reset. You can run a test load without any clothing to ensure that the reset worked.
What does F3 E1 mean on a Maytag washer?
washer can’t detect the water level
The F3 E1 alert indicates the washer can’t detect the water level. There may be an issue with the appliance control unit or associated wiring. Shut off water valves to the washer, and call for service.
What does eo1 mean on a Maytag washing machine?
An error code E01 F09 on the screen of your Maytag or Whirlpool Duet washing machine could indicate that you have a drainage issue. And guess what? You don’t even need to call the repair service center to fix the problem. The error is pretty common, and most users can fix it in a matter of minutes.
How do you clear the error code on a Maytag Centennial washer?
To exit the Maytag Centennial diagnostics press and hold the “start” button for about 3 seconds. (Again… This will erase error codes in the Centennial washer’s memory.) Now you can do run a Maytag Centennial automatic diagnostic washer cycle.
What does E01 and F03 mean on a Maytag washer?
The Maytag washer error code F03 E01 means two things. The main problem is your washer’s control board can’t sense the water level. This could be because of a bad pressure sensor, wiring, a bad control board, or a clogged air pipe. The other code tells you the door is locked.
Why is my Maytag washer not working?
When your washer isn’t working right, the solution may be as simple as switching up detergents, tightening a hose or leveling the appliance. Some issues will require professional help so it’s important to know what you can do yourself and what you’ll need a service call for.