What is a boat trim switch?
The Transom Trim Control Switch provides a weatherproof tilt control system at the stern area of the boat to facilitate placing motor support in position with one person. Switch can also be used for remote adjustment of hydraulic jack plates.
What does the trim switch do?
Trim is controlled with a toggle button on the control lever or on the dash. The trim system uses hydraulic rams to change the angle of the outboard motor or sterndrive gearcase—and with it the angle of the propeller shaft—relative to the boat transom, through a range of about 20 degrees.
What does a tilt trim limit switch do?
The Trim Limit Switch is a safety device which keeps the driver from over-trimming while under way. Trimming the drive too high while under way can cause damage, injury or death. The Trim Sender Switch is used to send a signal to the Trim Gauge so you can see the level of the drive.
Why is the trim on my boat not working?
Electrical or tilt/trim motor issues If you try to raise or lower the engine and nothing happens, first check to make sure that the battery is charged and that the battery switch is in the “on” position. Next, listen for the solenoid/start relay while operating the control (tilt) switch up or down.
When should I trim my boat motor?
Start with trim down: When you’re taking off from displacement speeds, most boats work best with the engine and bow trimmed down — this helps the boat rise quickly onto the plane. However, once your boat is on plane, it’s important to adjust the trim based on the sea conditions.
How do I check my Trim Limit Switch?
To test the limit switch circuit, lower the OD to the down position and slowly raise it with the trim toggle up until it stops. Then measure the distance between the trim cylinder attaching bolts.
How do you jump a trim solenoid?
Use a short piece of wire as a jumper and jump it across the small red and small blue wires on the UP solenoid. MOTOR SHOULD RUN but may just click. IF IT JUST CLICKS then jump across the large red and large blue wires.
How does the trim gauge work on a boat?
Trim level gauges are designed to display the trim and / or tilt angle of the outboard motor or outdrive unit. These trim gauges are available from Faria Beede and Kus. The signal to operate the trim level gauge comes directly from the OEM sender supplied with the outboard motor or outdrive unit.