Table of Contents
How do you install Stage 1 Snow performance?
- Step 1 Self Sealing Low Level Sensor Install (Optional)
- Step 2 Tank Install.
- Step 3 Pump Install.
- Step 4 Nozzle Selection.
- Step 5 Nozzle Mounting.
- Step 6 High Flow Check Valve Install.
- Step 7 Electrical / Injection Settings.
- Step 1 Boost Switch.
How do you use snow performance?
Step 1: Arm the system by putting the key in the ignition Step 2: Make sure fluid is in the water-meth tank Step 3: Remove nozzle from intake location and place in highly visible area Page 11 Page | 11 Step 4: Hit the prime button on the VC-50 controller.
Where do you put the methanol injector?
Where to locate Methanol injection nozzle
- Pre-Turbo water. We don’t recommend this location at all, if you do not have the proper equipment, such as, the proper nozzle, nozzle size and high pressure pump.
- Pre-Intercooler.
- Post Intercooler.
- Pre-Air Intake Temperature Sensor.
- 5 .
- Intake manifold.
How does water/methanol injection work?
Water/methanol injection systems deliver a finely atomized mist of a water/methanol mixture to an engine’s cylinder charge, and as the mixture absorbs heat and vaporizes, temperatures inside the cylinder are reduced and the propensity for detonation is decreased.
How does a boost cooler work?
Snow Performance’s Boost Cooler takes intercooling to another level, chemically. The system injects a mixture of water and methanol into the intake tract and ultimately into the combustion chamber along with the existing air/fuel mixture.
What is the part number for snow performance boost cooler gas injection?
Snow Performance Boost Cooler® Gas Water-Methanol Injection Kit Instructions (Part#’s 201, 201-BRD) CAUTION: You must completely read through these instructions before installing and operating this product.
How do I install my snow performance controller box?
Take your Snow Performance Controller Box, ensure the bottom is clean and apply strips of 3M tape liberally. Ensure your fuse box cover is clean. Remove red backing from the tape and stick the Controller Box onto the fuse box cover.
How do I return a part to snow performance?
[email protected] with a copy of your purchase invoice for the product, getting an RMA (Return Merchandise Authorization) number, and delivering the part to Snow. Customer agrees to insure the Product or assume the risk of loss or damage in transit, to prepay shipping charges to Snow, and to use the original shipping container or equivalent.
How do I get a warranty for my snow performance product?
Warranty service may be obtained by emailing [email protected] with a copy of your purchase invoice for the product, getting an RMA (Return Merchandise Authorization) number, and delivering the part to Snow.