How do you reset a Dixell refrigerator?
Resetting the Temperatures
- With either the maximum or minimum temperature displayed, press and hold the SET button for more than three seconds. The “rSt” message will display on the screen.
- The controller confirms the reset by having the “rSt” blink. After this, the normal temperature will display on the screen.
How do you reset a dixell fridge?
What is the correct temperature for a commercial freezer?
0 degrees Fahrenheit
For proper food storage, the ideal temperature for commercial freezers is at or below 0 degrees Fahrenheit.
Is 1 or 5 coldest in the fridge?
So on a refrigerator what setting is coldest (1 to 5)? On every fridge the rules for the coldest settings are always the following: The numbers on the fridge’s temperature dial indicate refrigerant power. The higher the number goes the colder the fridge will maintain. Setting it to 5 will make your fridge the coldest.
What are the default temperature settings for xr75cx?
Table 19-1- XR75CX Default Setting Values (2Only for XR75CX with X-REP output) 28 • XR75CX I&O Manual 026-1210 Rev 3 03-FEB-2015 dtEDefrost termination temperature [-50 to 50°C] [-50 to 122°F] [8°C] [46°F] Pr1
What is an xr75cx controller?
GENERAL DESCRIPTION Model XR75CX, , format 32 x 74 mm, is microprocessor based controller, suitable for applications on medium or low temperature ventilated refrigerating units. It has 4 relay outputs to control compressor, fan, defrost, which can be either electrical or reverse cycle (hot gas) and light (configurable).
How do you use the xr75cx front panel key?
Figure 4-1- XR75CX Front Panel Key Function Press to display target setpoint, to select a parameter in programming mode, or to confirm an operation Starts a manual defrost Press the UP arrow key to see the MAX stored temperature, to browse the parameter codes in programming mode, or to increase the displayed temperature value.
How do I connect the xr75cx to the E2?
To enable communications between E2 and the XR75CX units, the devices must be added and ad- dressed in E2. 1. Log in to the E2 with Level 4 access. 2. Press - Connected I/O Boards and Controllers. 3. In the Num Network Ctrls: NetSetupscreen, under the ECTtab, enter the number of devices in the Quantityfield.