How do I set my SmartRG to bridge mode?

How do I set my SmartRG to bridge mode?

SmartRG 808 Bridge Mode

1. Connect a device via an Etherent cable to the 1st LAN port.
2. Remove all other Ethernet cables to all other LAN ports.
3. Disconnect the coaxial cable from the SmartRG 808.
4. When prompted login using the username of admin and the password on the bottom of the modem.
5. Click Connection.

How do I connect my SmartRG to WiFi?

SmartRG 808AC

1. When prompted to login with a username and password, use the username and password located on the bottom of the modem.
2. Click Wireless.
3. Click Radio.
4. Set the Wireless Interface drop down menu to 2.4 Ghz.
5. Click Primary Network.
6. Enter your desired wireless network name into the Network Name (SSID) field.

How do I get WPS to work on SmartRG?

The SmartRG SR515ac supports push-button WPS and it is disabled by default….To enable it:

1. Log into the modem’s interface at 192.168. 1.1/admin.
2. Click “Wireless”
3. Click “Security”
4. In the drop-down menu under “Enable WPS”, select “Enabled”.
5. Click “Save/Apply” to commit your changes.

How do I access my SmartRG router settings?

Open your web browser of choice and type IP address of your SmartRG router in the address bar. You can find the ip address on the back of your router. Now enter the default username and password of your router by accessing the admin panel.

How do you Bridge a router?

How to Set Up Bridge Mode

1. Open a web browser from the device that’s connected to the network of the router that will run in bridge mode.
2. On the login screen, enter the router’s username and password.
3. Head over to Settings > Advanced Settings > Advanced Setup > Wireless Bridge.
4. Click the Enable Bridge Mode checkbox.

Is SmartRG a modem or a router?

SmartRG SR505N – Wireless router – DSL modem – 4-port switch – ATM – 802.11b/g/n – Walmart.com.

What is the password for SmartRG?

The default username for your SmartRG router is admin. The default password is admin.

How do I access my SmartRG modem?

Log into Modem Web Interface Enter http://192.168.1.1 info the address bar at in your web browser. Click on Manage Gateway (advanced) and login with username: admin and password: admin (if your modem has been properly reset. If not try your NCF DSL password).

Can I use my own router with the SmartRG?

If you prefer using your own external router to the one built into your SmartRG unit, we recommend routed operation with a separate WiFi Router. However if you have networking expertise and are confident using the modem in bridge mode then take note of the following before configuring your SmartRG for Bridged operation:

What should I do after configuring my SmartRG modem for bridged operation?

Once you complete configuring your SmartRG modem for Bridged operation and disconnect from the modem, the Modem’s Web Interface will become inaccessible with Auto DHCP settings on your computer. We recommend: Backup Settings: It is particularly important to backup the Running Settings on your modem before and after you configure it.

How do I Configure my NCF SmartRG modem?

NCF Support is available to make configuring your SmartRG modem easier and to help you avoid potential mistakes. Here are simpler configuration options for your SmartRG modem: You can request a custom configuration file for your NCF DSL connection from [email protected] .