How do you turn on a parrot rolling spider?

How do you turn on a parrot rolling spider?

Insert the battery into the battery compartment or tap on the On/Off button to switch on the Parrot Rolling Spider. The On/Off button is located under the Parrot Rolling Spider, below and to the right of the vertical camera.

How do I reset my parrot rolling spider drone?

To perform a factory reset of Parrot Mambo minidrone, perform these steps:

1. Switch On the Parrot minidrone, and wait for the LEDs to turn green.
2. Press the Power button again and keep it pressed for about 30 seconds.
3. Clear the memory of the minidrone (see Troubleshooting by Clearing Parrot Minidrone Memory).

How do I connect my parrot drone to my computer?

Prerequisites

1. Switch On the Parrot Rolling Spider. The On/Off button is located under the minidrone, near vertical camera.
2. Insert your Bluetooth 4.0 adapter into a USB port on your computer.
3. Install the correct Bluetooth driver for your adapter.
4. Turn on the Bluetooth support on your computer.

How do you reset a Parrot Drone?

Switch on the Bebop 2 drone and wait for the LED at the back to stop flashing. Press the Power button again and keep it pressed for about 10 seconds. After this, the Bebop 2 LEDs will flash, and the drone will restart. This will take several minutes.

How do I update my Parrot mini drone firmware?

Perform these steps to update the firmware:

1. Plug the battery in the minidrone to start it.
2. Launch MATLAB®.
3. Click on Setup (Gear Icon).
4. In the Hardware Setup screen, select I have a CSR dongle and drivers and then click Next.
5. Complete the steps on the screen of Hardware Setup.

How do I connect my Parrot drone Bluetooth?

How to connect Parrot Rolling Spider?

1. Download the FreeFlight Mini app. Like the Parrot MiniDrone, the Parrot Rolling Spider uses the Parrot FreeFlight Mini app.
2. Activate your smartphone’s Bluetooth.
3. Power on your drone.
4. Launch the FreeFlight Mini app.

How do I get my pictures from my Parrot drone?

Use a microSD to SD card adapter to transfer videos and photos you have taken with your ANAFI series drone to your computer. Slide the microSD card into the adapter and use the adapter how you would use any other SD card: access your videos and photos through a card reader or the SD card slot of your computer.

How do you set up a parrot drone?

How to Set Up a Parrot Bebop 2 Drone

1. Charge your Parrot drone’s battery.
2. Install the propellers onto the drone.
3. Install the companion app onto your mobile device.
4. Connect your mobile device to the drone.