Table of Contents
How do you check iR on iCharger?
Checking iR is easy. Connect the battery onto the charger with main- and balance leads. Press the „status“ botton for 2 seconds. Then the charger shows single and overall iR values.
How do I update my iCharger?
To update your iCharger Duo download and install the upgrader software (compatible with Windows XP, Vista, Windows 7-11): iCharger Upgrader v2….Then install the update file for your iCharger Duo using the included USB cable:
- iCharger 4010Duo v2.
- iCharger 308Duo v2.
- iCharger 406Duo v2.
How do you calibrate an iCharger x6?
Connect the battery to the iCharger main charge port and balance port. 3. Hold the button for 3 seconds to access the monitor mode screen. On this screen you can calibrate input and output voltages, as well as internal and external temperature.
How do you calibrate an iCharger?
- While holding buttons, power on your iCharger.
- Connect the battery to the iCharger main charge port and balance port.
- Hold the button for 3 seconds to access the monitor mode screen.
- Hold the button for 3 seconds to enter the calibration mode, then press the button to navigate to the value you wish to calibrate.
How do I use OneKey Optimizer?
Solution
- Open OneKey Optimizer from the taskbar or search for OneKey Optimizer.
- Select Save Power. Go to Battery Conservation, then click Calibrate.
- Choose a proper start time, then click OK.
How do I calibrate my Lenovo laptop?
Re: How To: calibrate Thinkpad laptop
- Right-click on the desktop and select Display settings.
- Click “Advanced display settings” at the bottom of the settings window.
- Verify that your monitor is set to the recommended, native resolution.
- Click “Color calibration” at the bottom of the advanced display settings window.
What should you not do with a LiPo battery?
Never leave your LiPo batteries charging while unattended. If a battery starts to become puffy, smoke, or catches fire you need to be able to immediately handle the situation. Walking away for even just 5 minutes can spell disaster.
Is OneKey optimizer good?
OneKey Optimizer is a powerful, next-generation system optimization software designed specifically for Lenovo computers. It can enhance your PC’s performance by updating firmware, drivers, and pre-installed apps. It also provides power management schemes that can extend the life of your battery.
How do I calibrate my battery with one key Optimizer?
What makes the 4010duo so special?
The 4010DUO uses advanced Synchronous buck-boost DC/DC converter technology, high power, a high current and high-performance power conversion circuit. The maximum charge power capacity is up to 2000W, the maximum charge/discharge current of a channel is up to 40A, and two channels in Synchronous Mode are up to 70A. 2.
What is the maximum charge current of the 4010duo?
The hardware programming can be updated through the USB port. The 4010DUO also supports “Logview” software to display, plot and analyze the charge and discharge data. Maximum charge current of up to 40A in Asyn. Mode, 70A in Sync Mode
How to set up the 4010duo parameters setup?
4010DUO Parameters Setup 4010DUO Parameters Setup Press TAB/SYS button for 2 secondson the initial interface to enter the SYSTEM MENUinterface, setting and testing of the system parameters, storage and servo can be completed on this interface. Charger Setup
Can I charge 2 batteries at the same time with 4010duo?
4010DUO is a dual port charger, but this does not mean you can charge/discharge any configuration of the two sets of batteries! You must follow these rules: two battery packs without any external electrical connections, otherwise they could permanently damage the charger or batteries.