Table of Contents
How do I reset my Drayton Digistat RF?
To do this, remove the batteries, press and hold the ‘set’ button whilst refitting the batteries, keep the ‘set’ button held and after a few seconds the display will show ‘rF’ which indicates that the Digistat+RF is continuously sending an OFF signal to the SCR (receiver).
How do you reset a Drayton wiser thermostat?
Twist and hold the cap of the radiator thermostat in the ‘-‘ direction. Wait a few seconds until the centre LED begins to flash Red. Keep holding the cap in the ‘-‘ direction and wait for 8 red flashes, which may take 20 seconds. Release the cap; all 3 LEDs flash once to indicate that the device is resetting.
How do you turn on the heat on a Digistat?
To switch On the Digistat+2 enter user options select option 8 and use + or – keys to select Off to disable the Off function. The thermostat will now regulate the heating system in line with the currently selected program.
Is there a manual for the Drayton digistat RF2?
This manual comes under the category Thermostat and has been rated by 2 people with an average of a 8.2. This manual is available in the following languages: English. Do you have a question about the Drayton Digistat RF2 or do you need help?
How do I resend and test the signal of my digistat RF unit?
To resend and test the signal, go to the Digistat RF unit. If the flame symbol is visible on the display, press the ‘–’ button until it disappears. If the flame symbol
How do I Reset my digistat to factory settings?
Reset If at any time during the programming you get confused and would at the same time and hold for two seconds. This resets the Digistat to the factory preset times and temperatures shown in the table (overleaf). 5. Self revert If during programming no button is pressed for between one and
How do I test my digistat SCR?
Pull down the battery drawer in the Digistat unit and the screen will go blank. Turn off the power supply to the SCR receiver unit and leave for 5 seconds. Turn the power back on to the SCR unit and check red light is on. To check the SCR is wired correctly, press the override button No.2 once and check the green light comes on and boiler fires.