Table of Contents
What does X over mean on my amp?
CROSSOVER
CROSSOVER (X-OVER), is a tuning setting that usually has predetermined frequency ranges depending on the setting you choose. For example, LPF (sometimes referred to as LP) refers to Low Pass Frequencies and is used for subwoofers designed to play only the lowest notes.
Should I use subsonic filter?
Registered. Yes, you definitely want to run a subsonic filter when using a ported box. The port acts as part of your subwoofers suspension and once you’re below the tuning frequency it becomes an extra stress on the soft parts and loses it’s ability to maintain linear control over your cone movement.
Do you need a subsonic filter with a sealed box?
You don’t need subsonic filters with sealed because the air acts as a spring, preventing over-excursion. You can still set the filter, but it’s not usually necessary or desired.
What should my LPF be on my amp?
As a general rule, the Low-Pass Filter should be set at a value approximately equal to (or below) 70% of your main speaker’s lowest frequency response. For example, your speaker’s frequency response goes down to 43Hz. 70% of 43Hz equals 30.1, so you should set the subwoofer’s low pass filter to 30Hz.
What should my subsonic be set at?
For the mainstream listener, setting a subsonic filter around 35 Hz will allow them to hear all their music content, missing nothing on any performance, while protecting their system.
What should subsonic filter be set on sealed box?
You can still turn on your subsonic even on a sealed box. A good point to set it is 25hz. It can help your amp save power when the bass gets real low. it’ll help keep your subs from bottoming out from receiving too much power or being in too large a box or just being crappy subs.
What should I set LPF to?
How do I use subsonic on Windows 10?
Using network disks in Windows 1 Open Services in Windows. 2 Right-click the Subsonic service and select Properties. 3 Click the Log On tab. 4 Activate This account and enter your Windows username and password. 5 Click OK and restart the service.
How do I Start/Stop subsonic?
It also creates links in the Start Menu: Start > All Programs > Subsonic. From this menu you can start/stop the Subsonic service, open the Subsonic web page, or change basic settings such as which port number Subsonic should use. You can also click on the little yellow submarine tray icon.
What is a subsonic blackout?
Hornady® 300 Blackout Subsonic Ammunition is designed for accuracy and performance below the speed of sound. The new 190 gr Sub-X® (Subsonic – eXpanding) bullet features a lead core.
How do I enable subsonic for mapped networks?
By default, mapped networks disks are not visible to services. To fix this you can change the Subsonic service to run as the logged-on user instead of the System user. Open Services in Windows. Right-click the Subsonic service and select Properties. Activate This account and enter your Windows username and password.