What is the best line trimmer head?
Husqvarna Universal T35 Tap Advance.
Who makes speed feed trimmer heads?
ECHO’s
ECHO’s patented revolutionary Speed Feed trimmer head. Take the hassle out of refilling your trimmer head by using the easiest loading tap to advance head available. Speed Feed 400 reloads in under 30 seconds with just three easy steps, all without taking the head apart.
What is the difference between speed feed 400 and 450?
The Speed-Feed® 400 is universal and includes adapters for use on both straight shaft and curved shaft models (non-bulk pack only). The Speed-Feed® 450 trimmer head is for units above 24cc.
How do I replace the trimmer head?
Replace the trimmer head Remove the spool of line from the trimmer housing. The most common method is to push in, twist and pull off the spool. If your trimmer head differs, follow the manufacturer’s instructions to remove the old head. The head is attached to the trimmer with a retaining nut or bolt.
How much string do you put in a weed eater?
Push about 1/2-inch of one end of the string in the hole, so the hole holds the string in place while you load the spool. If your weed eater uses two strings, the spool should have two sections separated by a divider, with a hole in each section. Wind one piece of string at a time in two-string weed eaters.
What are the parts of a Troy-Bilt weed trimmer head?
The trimmer head on a Troy-Bilt weed trimmer contains the inner reel, cutting line, spring and outer head. These parts can be removed to replace the trimmer head on the trimmer. The trimmer head can break, the spool can crack and the spring may no longer function, all of which will require replacement of the broken part and the cutting head.
How do you clean the inside of a Troy Bilt Trimmer?
Step 1. Turn off the power switch on the Troy-Bilt trimmer. Lay the engine flat onto a workbench, head tilted up. Grab hold of the moving head. Unscrew the bump knob counterclockwise. Remove the bump knob and inner reel. Clean the area inside the head with the rag.
What tools do I need to install a Troy-Bilt Trimmer?
Troy-Bilt trimmer heads are designed for easy, user-friendly removal and installation. In some cases, the only tools you might need are a flat-head screwdriver and/or a hex key.
How do you change the head on a Craftsman power Trimmer?
Pull the engine spark plug wire from the spark plug by hand to prevent accidental engine starting when removing and replacing the trimmer head. Loosen the two trimmer head retaining bolts with a socket wrench, spreading the trimmer head open enough to clear the spindle head and spindle head stops.