What is Trimdek used for?
Also known as: Trimclad, Superdek and Monoclad COLORBOND® steel Trimdek Lysaght roofing sheets are used on roofs with a minimum of 2 degree of fall or greater. It is screw down metal deck roofing iron, which makes it very easy to install. These roofing sheets are a cost effective alternative to Klip-Lok roofing sheets.
What is Trimdek made of?
steel
lysaght trimdek is made of high strength steel and despite its lightness, provides excellent spanning capacity and remarkable recovery after deformation. the strength, spanning ability, lightness and rigidity of lysaght trimdek permits wide support spacings to be used with safety. Sheets are supplied custom cut.
What is the minimum pitch for Trimdek roofing?
2 degrees
Trimdek. Requiring only a minimum pitch of 2 degrees Trimclad® roofing and walling is a preferred choice for commercial and industrial uses.
How wide is a Trimdek roof sheet?
What is the sheet cover of the Trimdek Sheets? The cover width is 762mm. The actual sheet width is 820mm.
Where do you put TrIMdEk screws?
you can place screws for LySAGhT TrIMdEk through the crests or in the pans. To maximise watertightness, always place roof screws through the crests. For walling, you may use either crest- or pan-fixing. Always drive the screws perpendicular to the sheeting, and in the centre of the corrugation or rib.
What do you put under metal siding?
Metal siding requires an underlayment to protect against weather conditions and form a tight seal. Breathable, synthetic material is preferable. This can allow moisture to escape without allowing it in, which will help preserve the undersurface. This can be attached using a staple gun.
Where do you put Trimdek screws?
What is trimdek cladding made of?
Trimdek/Monoclad® cladding is manufactured from hi-tensile G550 colour coated steel or zinc aluminium alloy coated steel. In some locations galvanised and severe environment colour coated steel may be available by arrangement. Colour coated steels are in accordance with AS2728 – Category 3 and, for the substrate, with AS1397.
What is Lysaght trim deck?
LYSAGHT TRIMDEK® is a versatile roof and wall cladding featuring bold, trapezoidal ribs and subtle fluting in the pans. Ideal for commercial, industrial and residential buildings. It can be used with the LYSAGHT TRIM-KLIP® end and expansion joint system.
What is the trim-Klip® system?
The TRIM-KLIP® system comprises a fully engineered steel bracket and a custom profiled weatherstrip. The statements, information, and opinions quoted are provided by the featured supplier. BlueScope Steel Limited does not warrant the accuracy or currency of the content and is not responsible or liable for content provided by third parties