Where is the pilot light on my furnace?
Near the bottom of your furnace is a switch that normally says “Pilot,” “On” and “Off.” Find this switch and turn it to the “Off” position. Wait at least five minutes. This is important because it gives the gas time to dissipate, which is necessary to avoid possibly starting a fire.
Where is my pilot light on my furnace?
Step 1: Find the pilot light assembly. It’s usually near the bottom of the furnace and has a gas valve with on, off, and pilot settings. Step 2: Turn the valve to off and wait three minutes. No tools should be required to do this.
Why won’t My Bryant heater turn on?
Check the circuit breakers at the electrical panel. Check the SSU switch (it looks like a light switch on a gray box located at the furnace) to be sure it is in the “ON” position. Check to ensure the furnace filter isn’t in need of replacement. All one-inch thick furnace filters should be replaced monthly.
How do you light a pilot light manually?
A pilot light is a small blue flame that ignites a gas appliance….How to Light a Furnace Pilot Light
- First, locate the pilot valve on the furnace.
- Find the gas valve and turn it to the “off” position.
- Turn the valve to the “pilot” position.
- Press and hold the reset button.
- If the reset button fails, ignite the lighter.
Why won’t my pilot light on my furnace?
Common Reasons Your Furnace Pilot Won’t Light There are several possible reasons why your gas furnace pilot won’t light: an ongoing draft, a faulty thermocouple, an accumulation of dirt, or an inefficient supply.
What would cause a pilot light to go out on a furnace?
Thermocouple Malfunction It is positioned very close to the flame, and when lit, the pilot light tells the thermocouple to keep the gas line open. A thermocouple that is dirty or malfunctioning will often shut off your gas supply in error, causing the pilot light to go out and your furnace to stop working.
How do you restart a furnace?
How Do You Reset a Furnace? The Ultimate Guide
- Find the switch mounted on or near the furnace and turn the power off.
- Wait about 10 seconds.
- Turn the switch or breaker back on and check the furnace to see that it has power again.
Where is a pilot light located on a furnace?
The pilot light is located within the burner assembly inside your furnace. To access it, remove the access cover to access the burner assembly. Then look toward the bottom. You’ll see a dial (usually red) that says “ON,” “OFF,” and “PILOT.” This is the gas valve knob we mentioned earlier.
How to light a water heater pilot light?
Turn all the stovetop control knobs to the “off” position.
How to relight your furnace pilot light?
Read the manufacturer’s guidelines for your furnace. Be sure to follow any specific instructions or warnings.
How to light the standing pilot on a gas furnace?
– Turn your thermostat to a setting that will demand heat (like 85 degrees). Make sure the thermostat is set to the HEAT mode. – Go to the furnace and find the pilot valve. – Turn the knob or gas cock to the OFF position and wait about three minutes for any residual gas to clear away. – Find the pilot tube and nozzle. – Get your match or lighter ready.