How do I access my TPG router settings?

How do I access my TPG router settings?

Open your browser and in the address bar type http://192.168.1.1 and press Enter. Enter admin for both the username and password and click Login. If you have changed the login credentials, please enter the current username and password for the modem/router interface.

Does TPG use PPPoE?

NETWORK CONFIGURATION PPPoE connection uses authentication to establish the Internet connection and once connected your modem will be assigned an IP and DNS settings from TPG.

Is TPG ADSL or VDSL?

TPG’s equipment uses either ADSL2+ or VDSL technology over the copper cables within the building. We do not guarantee provision of Service to every applicant. The Service is only available to addresses within relevant network coverage area where there is available infrastructure to provision the Service.

How do I find my TPG PPPoE username and password?

Setup for PPPoE uses your TPG username with @TPG.com.au on the end and your password. Your username and password can be checked by logging onto My Account. If you are on FTTP, that’s all you need.

What connection type is TPG?

Check out the step-by-step instructions to connect the TPG 5G Home Broadband equipment and cables in your home: 5G. 5G Modem….New Connection Setup Help.

What is my PPPoE username and password TPG?

General Settings

Which network does TPG use?

Vodafone mobile digital network
TPG’s underlying mobile network is the Vodafone mobile digital network (2G/3G/4G).

What network does TPG use for broadband?

WHAT IS FTTB? TPG Fibre to the Building (FTTB) is a high-speed broadband service delivered on our own fibre optic network that has been installed in many metro apartment buildings across Australia.

What server does TPG use?

General Settings

How do I set up my ADSL modem?

1. Open up a web browser and type in theIP address of the DSL-300T (default is 192.168.
2. Enter the Login nameand password (default is admin/admin).
3. Click on the Setup tabat the top.
4. Configure the following for yourconnection:
5. Click on the Statustab at the top and then click on Connection Statuson the left side.

Why is my TPG internet not working?

Try resetting your TPG NBN router to factory defaults and then reconfiguring it with your TPG settings. To do this press and hold the reset button on the back of the TPG NBN router for ten seconds. To reconfigure your TPG NBN router please refer to the quick reference guide which was supplied with the router.

Do I need to configure my modem with TPG?

Note: If you get your modem from TPG, you are not required to configure your modem as TPG has already configured your modem with your account details. Otherwise please proceed to Advanced Modem Setup.

How do I Change my WiFi settings on TPG?

Enter your TPG username and password. Click Next . You can change your WiFi details or choose to keep the default settings. The default WiFi SSID is printed on the sticker underneath your modem. The WiFi password is set to your TPG ADSL password by default.

How do I set up my modem for ADSL2+ broadband?

This article provides modem setup advice for ADSL2+ Broadband to get you up and running in just a few simple steps; With the supplied Power cable, connect the Power porton the back of your modem to your power point. With the supplied Ethernet cable, connect your PCto any of the 4 LAN ports on the back of your modem.

Does my ADSL2+ modem need a filter?

Your ADSL2+ modem does not require a filter to work properly, however other telephony device s (e.g. telephone) connected to the same phone wall socket as your modem does require a filter. In this situation you need an ADSL splitter.