How do I reset my Hayward Aqua Rite salt chlorinator?
Reset AquaRite Salt Chlorination Inspect Cell Light If the Inspect Cell Light is the only LED light flashing, then you can reset it by simply holding down the diagnostic button for 3 seconds, then release. The Inspect Cell indicator will now reset and will later come back on after another 500 hours of use.
How do I reset my Aqua Rite chlorinator?
To reset, move the switch to ‘Off’ and then back to ‘Auto’. Wait for the relay to click (5 to 10 seconds). When the instant salt level is stable (and the negative sign still present), slide switch to ‘Super Chlorinate’ and back to ‘Auto’. It takes about 30 seconds for the unit to settle back on the default reading.
How do I reset my Pentair salt cell?
Press the “More” button to cycle through each salt level, and then press the “Less” button to choose and save the display as the new salt level. The “PWR”, “Cell”, “Life”, and “Flow” lights will flash 4 times, then the mode exits to normal.
What happens if salt level is too high in pool?
Bottom Line. A little bit of extra salt in your pool doesn’t generally result in any concerning issues. However, putting in excessive amounts of salt, resulting in salt levels 5000 ppm or more, can lead to corrosion of your metal pool equipment. Not to mention, having too much salt will also make the pool saltier.
Why is my Hayward salt system not producing chlorine?
Water flow The saltwater chlorinator needs a sufficient flow of water for effective operation. A dirty skimmer basket, clogged or dirty filter, and a clogged pump strainer, can cause insufficient water flow for the chlorinator to produce less chlorine.
How do you calibrate Aqua pure salt?
Press and hold the ‘Pool Temperature’ (‘D’) key for 15 seconds. The system will beep when the button is pushed, it will beep again after 10 seconds, and again after 15 seconds. Release the key after the third beep. Press ‘Salinity’ (‘C’) key within 5 seconds to enter temperature change screen.
How do you bring salt levels down?
The only way to lower the salt concentration of your swimming pool’s water is to dilute it. Unfortunately, this means you will need to partially drain your pool and refill it with fresh water. This is true because salt doesn’t wear out, break down or evaporate; only your water will evaporate. First take a salt reading.
Can you shock a pool and add salt at the same time?
Should you add shock to a salt water pool? It’s absolutely okay to shock your salt water pool, and is actually pretty important!
How do I reset my Hayward check system?
Press the ‘Menu’ until, ‘Default Menu’ appears on the display. This menu is where the ‘Inspect Cell’ message is stored. Press the (>) key, repeatedly, until ‘Inspect Cell, Hold + to reset’ appears on the display.