How much oil does a Harley transmission hold?

How much oil does a Harley transmission hold?

approximately 24 ounces
When filling the transmission, use Harley-Davidson TRANSMISSION LUBRICANT (Part No. 99892-84 (qt.) or 99891-84 (gal.)). The transmission fluid capacity is approximately 24 ounces (0.71 liters). Inspect o-ring for tears or damage.

What kind of oil do you put in a Harley Davidson transmission?

Answer: For any Harley Twin-Cam engine, we highly recommend using AMSOIL Synthetic 20W-50 in “all three holes” (as they put it) for two essential reasons. Update: AMSOIL now offers dedicated fluid for Harley Davidson primary chain-cases and transmissions.

Do Harleys have separate transmissions?

Big Twin Harleys have separate transmission assemblies (the gearbox and the engine use different lubricants, allowing for extensive work to be done to the gearbox without splitting the engine cases) and left side final drive.

Can you use 75w90 in Harley transmission?

It will be just fine in the trans. I would recommend using gear oil in there over motor oil. I run amsoil v-twin transmission oil in my bike.

What is a 6 speed cruise drive transmission?

The 6-speed Cruise Drive transmission features quieter helical-cut gears in ratios optimized to match the torque curve of the Twin Cam 96. A sixth gear reduces engine rpm by 11 percent at highway speeds. New mufflers have been tuned to enhance the lower sound frequencies for a more commanding exhaust tone.

How many hours does it take to drop a transmission?

It usually only takes a day or two to replace a transmission in most rear wheel vehicles. However, some late-model, front-wheel drive vehicles can be quite labor-intensive and take three to four days.

How hard is it to remove transmission?

Depending on the year, make and model of your vehicle and the shop labor costs in your area, you can expect to save between $550 to $1,250 or more. The job of removing and replacing an automatic transmission is not tremendously difficult – it’s just a matter of being prepared, being safe, and following instructions.

Is it hard to remove a transmission?