Table of Contents
What axles are in a Jeep Wagoneer?
SJ Wagoneer: Grand Wagoneers, Full Size Wagoneers and Full Size Cherokees/Cherokee Chiefs came standard with Dana 44 front axles, and either the Dana 44 or AMC 20 rear axles.
How do you read axle measurements?
Most thru-axles are described by four measurements, and you might see them described something like this: 15 x 100mm, 127 length, 1.5. In this example, 15mm is the diameter, 100mm is the O.L.D., 127mm is the overall length and 1.5mm is the thread pitch. You can see more details about these measurements below.
How are axles measured?
Hook your tape measure on the outside of the hub where your rim touches your hub. Measure across your axle to the exact same spot on the other side. Do not measure to the back side of your hub. Brake Flange Measurement: Hook your tape measure to the outside of the brake flange that is welded to your axle.
What is the length of a Dana 44 axle shaft?
10112 Dana 44 30 Spline Chromoly Front Left Inner Axle Shaft from Alloy USA fits 1980-1991 Jeep SJ Wagoneer, Axle Shaft Measures 15.82″ long. 10123 Dana 44 30 Spline Chromoly Front Right Inner Axle Shaft from Alloy USA fits 1980-91 Jeep SJ Wagoneer, Measures 32.12″ long.
What is the length of a wagoneer front axle?
10111 Front Axle Shaft, Right Inner, 1974-1979 Wagoneer Alloy USA, 14.69″ Long, Chromoly, 30 Spline with Model 44 Front Axle . 10122 Front Axle Shaft, Left Inner, 1974-1979 Wagoneer Alloy USA, 33.19″ Long, Chromoly, 30 Spline with Model 44 Front Axle .
How wide is the dana44 diff?
They are WIDE TRACK… 63″ wms to wms. The front DANA44 is driver’s drop and the rear AMC20 is centered diff w/3:31s or 3:54s. Maybe a dealer option:question:
When did the Ford Bronco Dana 44 axle come out?
The Dana 44 became available in the early Ford Bronco’s from 1971-1977. Axles prior to that point were the Dana 30. 1971-1977 Ford Bronco Dana 44 Axle