Table of Contents
What does 94s mean on a tire?
Speed ratings indicate the load capacity of tires, and they also measure how fast a tire can safely drive for at least 10 minutes. For instance, when you see 94T, this means that the load rating is 94 and the T indicated is the speed rating. The typical speed ratings are S, T, H, Y, U, W, and V.
What is 98w tyre?
The load rating, represented by the numerical value, is directly related to the maximum weight that each tyre can carry. In this case, 98 would refer to a load capacity of 750kg. Most passenger vehicle load indexes range from 62 to 126.
What does the 95w on tires mean?
(95) Load Index To find out what “95” means, you have to look it up on a Load-Carrying Capacity Per Tire chart. Ninety-five indicates a maximum weight of 1,521 pounds. Remember that this is per tire, which means you have to multiply by four to get the total capacity for a complete set of tires.
What is speed rating V and W?
Then, as more manufacturers came out with tires that could handle speeds in excess of 149 mph but still hit a maximum speed at some point, “V” became limited (149 mph instead of 149+ mph) and “W” and “Y” speed ratings were added to the chart.
What does W and Y mean on tyres?
Z-rated high-performance tyres are rated for speeds in excess of 149mph. Confusingly, W-rated tyres are rated at a higher speed in excess of 168mph. Y-rated tyres are rated in excess of 186mph. See the full list below. Tyre speed ratings should be matched to the official top speed of your car.
Whats the difference between 94w and 98y Tyres?
One important factor to consider is the sidewall strength. The 94 load index tyre will have a weaker sidewall when compared to a 98 index tyre. That means on the same car with all conditions being equal the 94 index tyre will flex more and it’s contact patch may also vary.
What is speed rating W?
SPEED RATING W A relatively new addition to the speed rating chart, tires with speed rating “W” can achieve a maximum sustained speed of 168 mph (270 kph).
What is XL in tire size?
The XL stands for eXtra Load and means the sidewalls of the tire are stronger and capable of handling heavy load requirements. In many cases it is obvious why you would need XL tires, especially for limousines, trucks and utility vehicles.
Can I mix W and Y rated tyres?
Mixing tyre speed ratings isn’t recommended. If you are in a situation where you must mix tyre speed ratings (after an emergency puncture, for example) then make sure the lower-rated tyres are on the front axle to prevent turning more sharply than you intended (oversteering).
What does 95y mean on tires?
The number is the load index. The higher the number, the more weight the tires can handle. In this case, “96” means the tire can handle 1,565 pounds, while the “Y” indicates the tire is rated to be safe at speeds up to 186 miles per hour.
What does 114T mean on tire?
What ply is 114T? Light Truck Tires What does the T on a tire mean? If there is a “P” on the sidewall, it stands for “passenger car.” This refers to the U.S. (P-metric) method of tire sizing. “LT” stands for Light Truck, “ST” is for Special Trailer and “ T ” stands for Temporary, which is primarily used for small spare tires.
What is the difference between 95T and 95h tires?
What does 95T on a tire mean? Tire speed ratings, L thru Y and (Y), indicate the maximum speed the tire should be driven. L is for off road vehicles and indicates a maximum speed of 75 mph. The 95H tire has a higher speed rating compared to the 95T tire. The load index rating, 95, is identical.
What does 94v mean on tire ratings?
What does 94v mean on a tire? The letter part of this is the speed rating – the maximum supported speed for the tire. Again, from Tire Rack: So a tire rated at “94V” can support 670kg at 240km/h.
What is 100h on tire?
Identification. The tire data on the side of the tire will be in the form of this example: 235/60R17 102T.