Table of Contents
How do I reset my ubnt?
Restore to Factory Default Settings Press and hold the Reset button for more than five seconds. Alternatively, the UniFi AP may be reset remotely via a Reset button located on the bottom of the Gigabit PoE adapter. Cable Feed Plug If your Ethernet cable feeds along the mounting surface, remove the Cable Feed Plug.
How do I connect to ubnt?
Setting up a UniFi OS Console is easy. Start by connecting your console to the internet and powering it on. In the UniFi Network mobile app, log into your UI account and wait for the setup prompt to appear on your screen. Follow the on-screen instructions and you’ll be up and running in just a few minutes!
How do I set up ubnt?
Connect your computer’s Ethernet port to the LAN port of the same power injector. Once connected, launch your web browser and enter 192.168. 1.20 as the “URL” to gain access to the radio’s management console. Enter ubnt / ubnt for the username / password.
How do I reset my PowerBeam m5?
Technology Page 4 Reset Button To reset to factory defaults, press and hold the Reset button for more than 10 seconds while the PowerBeam is powered on. Alternatively, the PowerBeam may be reset remotely via a Reset button located on the bottom of the PoE Adapter.
How do I access ubnt device?
Open your browser (e.g. Internet Explorer, Firefox, Opera, etc.) and type in address bar: http://192.168.1.20 (the default address of the Nano) then press the Enter key. Type in ubnt twice and click OK → (If this window did not appear, there may be a problem with the wiring, the network card or a firewall).
How do I find my ubnt IP address?
How to find the IP address for your Ubiquiti access point?
- Step 1: Download Ubiquiti locator. You can download the ubiquiti locator program here.
- Step 2: Run the program. Once you have unzipped the file contents, click on the program file as outline in the picture below.
- Step 3: Locate the IP address.