How much does it cost to replace injectors on a 6.6 Duramax?

How much does it cost to replace injectors on a 6.6 Duramax?

The total cost for Duramax injector replacement is $2,000 and $6,000. The labor costs associated with this job can range from $800-$1,500. Related repairs could be needed if you have driven for a long time with dirty fuel injectors.

How much does it cost to rebuild Duramax injectors?

Vehicle

Vehicle Labor Cost Parts Cost
6.6 Duramax $800-$1,000 $2,000-$2,500
2011 Silverado HD $1,000-$2,000 $3,500-$4,000
2008 Chevrolet Silverado $800-$1,000 $800-$1,000
2019 Chevy Silverado $800-$1,200 $2,000-$3,500

Are refurbished diesel injectors any good?

Since remanufactured fuel injectors have been rigorously tested and have had their internal parts replaced as needed, you get the reliability of a new injector. Plus, you get it at a lower price point. Remanufactured products are gaining ground because of these advantages.

Can diesel injectors be refurbished?

When it becomes necessary to replace the diesel injectors there are two options of you can take. You can get refurbished injectors or get remanufactured ones instead. Each has potential pros and cons that you may need to consider when choosing which is the best option for you.

What are the problems with the Duramax?

Fuel Injector Failure

  • Water Pump Failure
  • Fuel Filter Housing O-ring Leaks
  • Blown Head Gasket
  • Overheating (fan clutch problems,radiator gunk)
  • How to replace Duramax fuel injectors?

    Take off everything that’s in the way, R&R the injectors, the put the stuff you took off back on. Make sure you have new injector O-rings and metric line wrenches. Do you know if you need some sort of special Injector removel tool in order to remove the injectors from an LBZ?

    What are common problems with Duramax Diesel?

    Long Crank Start-up Time. If your 3.0 Duramax engine takes a long time to crank up,then it may have an issue with the glow plugs or glow plug wiring

  • Injector Failure.
  • Turbocharger Failure.
  • EGR Valve Failure or Stuck Open.
  • Worn Out Oil Pump Belt.
  • How do you change EGR valve on 03 Duramax?

    Loosen the outlet duct clamp at the upper intake manifold cover.

  • Remove the upper intake manifold cover from the outlet duct.
  • Remove the upper intake manifold cover.
  • Loosen the outlet duct clamps at the turbocharger and the mass air flow/intake air temperature (MAF/IAT) sensor.
  • Remove the outlet duct from the turbocharger and MAT/IAT sensor.