How do I change my Bushnell rangefinder back to the yard?
The rangefinder can be used to measure distances in yards or meters. The unit of measure indicators are located in the lower right portion of the LCD. To select between yards and meters, the unit should be off. While looking through the eyepiece, press and hold the POWER button down for approximately 5 seconds.
How do I adjust my Bushnell rangefinder?
Press the Power/Fire button and continue to hold it down until the display changes to a blinking “Y”-continue to hold the button down, and the unit indicator will switch to “M”-release the button now, and distances will now be shown in meters.
How do I change the mode on my Bushnell rangefinder?
Tap Mode button to cycle thru “Bright 1~Bright 4”. Press Power/ Fire to select your preferred display brightness setting. 6. Press Mode to cycle Yards/Meters distance units preference.
How do I turn off my Bushnell rangefinder?
Once your contacts are cleaned, connect the unit to your power source. To ensure the unit is receiving charge, hold down the bottom right hand button for up to 15 seconds. This is the power (ON/OFF) button that can be used for switching the unit on and off.
How do I change my Bushnell rangefinder to FEEt?
To select a different unit of measure, start with the rangefinder powered off. Press and continue to hold the Fire button. “Y”, “M” or “FEEt” will begin flashing, with the display slowly cycling through these 3 unit options (5,7b). Release the Fire button when your desired display units are flashing.
Why is my Bushnell rangefinder blurry?
If the reticle appears fuzzy, or requires a little time to come into sharp focus, further adjustment is needed. Turn the eyepiece clockwise another full turn and repeat STEP 8. 8. Keep doing this until the reticle is sharp the instant you put your eye to the scope.
How do you change the slope on a Bushnell?
7. Slide Slope Switch to left (red indicator visible) to enable slope compensated ranging, slide it to the right (red indicator hidden) to disable slope. 8. With slope mode enabled, tap Mode button to toggle Elements on/off, indicated by the Elements mode icon in the display.
Why does my Bushnell rangefinder not work?
A: Replace the battery when the unit does not turn on, display does not illuminate, or the display goes blank when attempting to power the laser. Use a good quality 3 -volt lithium battery (CR2). Insert into the compartment with the negative (flat) end first (positive end facing out towards the battery cover).
How do you set up a Bushnell Golf?
To access the Setup Menu, select Setup from the Golf Menu. Use the UP Button (3) and the Down Button (5) to scroll between options. Use the Select Button (4) to select the desired option. Select YDS/M to set your preference for unit of measurement in Play Golf Mode.
How do you set up a Bushnell golf?