What is the fuel mixture for a Homelite Super XL?
The recommended 50-to-1 fuel mixture includes 2.6 ounces of a high-quality, two-cycle oil with added fuel stabilizers and 1 gallon of unleaded 87-octane gas. Homelite recommends using their brand of oils, specifically designed to work in any model with a 50-to-1 fuel ratio.
Why does my Homelite chainsaw won’t stay running?
The carburetor might be clogged. A clogged carburetor is often caused by leaving fuel in the chainsaw for a long period of time. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and cause the chainsaw engine to stall.
What is the gas ratio on a Homelite chainsaw?
The recommended fuel mixture is a 50-to-1 ratio of unleaded gasoline and two-cycle engine oil, and the manufacturer recommends the use of a two-cycle oil that contains fuel stabilizer to keep the mixture fresh if you are not using it immediately.
How do I adjust the carburetor on my Homelite chainsaw?
Locate the three carburetor adjustment screws. These screws will either be located just above the gas tank or just above the clutch area, depending on the Homelite model, and will be deeply recessed. Use a flashlight, if necessary, to locate the carburetor adjustment screws. Make sure your fuel tank is at least ¾ full. Start the Homelite chainsaw.
How do you adjust the idle on a Walbro carburetor?
Walbro Carburetor Acceleration Idle the engine for a few seconds, then give it full throttle. The engine speed should ramp up to full speed within a few seconds. If it hesitates, turn the idle speed adjustment screw counterclockwise, no more than the width of the adjuster screw’s slot at a time, until you get a smooth acceleration.
What are some common problems with Homelite chainsaws?
Some Homelite chainsaws have a plastic stopping device that limits adjustment of the low and high speed screws. The company recommends taking a faulty chainsaw to an authorized repair center if the chainsaw’s speed cannot be properly adjusted with a slight twist of either screw.
How do you adjust the carburetor on a Husqvarna chainsaw?
Changing the carburetor setting involves adjustment of the idle-speed screw. The screw is located on the side of the saw just above the starter cord handle and blower housing. To adjust the idle speed, insert a screwdriver into the hole marked with a “T.”