Table of Contents
How do I factory reset my DrayTek 2862?
Log into the router’s web management page, and go to System Maintenance >> Reboot System. On the web page, choose “Using factory default configuration” and click Reboot Now.
How do I reset my DrayTek router?
The quickest way to reset the router is to select ‘reboot’ from the web configurator, and click the button for ‘factory defaults’. On the 2200/2600 series, you can instead press the reset button the the back of the router and hold it until the left-hand LED starts to flicker rapidly, then release the button.
What is the default password for DrayTek router?
DrayTek Router Login Guide The default username for your DrayTek router is admin. The default password is admin.
What is the default IP of DrayTek router?
DrayTek Access Point’s will receive an IP Address via DHCP automatically or if they are unable to contact a DHCP server they will use 192.168. 1.2 by default.
How do I reset my DrayTek router password?
Go to [System Maintenance] > [Admin Setting]. Enter the existing password in the Old Password box, then put the new password in both the New Password and Confirm Password boxes. Click OK to apply the change. The router will then display this message to indicate that the password has changed.
How do I reset my draytek router password?
How do I access my DrayTek router settings?
How to login my Vigor Router
- Connect a computer to one of the router’s LAN ports by an Ethernet cable.
- Make sure the network interface is using an IP in the 192.168.
- Open a browser on the computer.
- After logging in, you will access the management page of the router.
How do I reset my vigor 130?
To reset the DrayTek Vigor130 to its default settings, you have to do the following steps:
- Switch on router.
- For at least 10 seconds, press the Factory Reset button.
- Device is automatically restarted.
- Default settings have been restored.
How do I change my DrayTek router username and password?
How do I configure draytek router?
Access the DrayTek router’s web interface via your web browser, which will be accessible on http://192.168.1.1 by default. Enter the username of “admin” and the default password of “admin”. 2. Browse to [WAN] > [General Setup], click [WAN1] and set the VLAN Tag insertion (VDSL2) setting to Enable.
How do I access draytek vigor 130?
With that connected, the Vigor 130 modem’s web interface can be accessed on http://192.168.2.1 with a username of “admin” and a password of “admin” by default. In the modem’s web interface, go to [Internet Access] > [General Setup], on that page, the VLAN Tag insertion (VDSL2) setting will be enabled and set to 101.