How do I reset my DNS-323?
To reset the DNS-313/323, access the management (web GUI), go toTOOLS – SYSTEM and press Restore. Allow a minute for the device to reset. If you cannot reach the web UI, locate the reset button on theback of the DNS-313/323.
How to connect DNS-323?
The simplest way to access your DNS-323 is to use theEasy Search Utility provided on the CD-ROM. Thiswill automatically detect any DNS-323 devices on your network,allow you to set up network drives in Windows, perform basicconfiguration and access the web configuration interface.
How do I find my DNS 323 IP address?
Type 192.168. 0.32 (the default IP to access the admin interface) in the address bar of your internet browser to access the router’s web-based user interface. You should see 2 text fields where you can enter a username and a password. The default username for your Dlink DNS-323 is admin.
How do I soft reset my Dlink router?
Power OFF the device. Press and hold the ‘reset’ button; while doing so, power on the device again and keep holding the ‘reset’ button for another 10 seconds. Then release the button and wait until device restarts.
How can I format my Dlink router?
How do I reset my router to factory default settings?
- Step 1: With the router on, insert the end of a paper clip into the pinhole highlighted below.
- Step 2: Hold the paper clip down for 10 seconds and release.
- Step 3: The unit will reboot automatically. Once the WLAN light stops blinking, the unit has been reset.
- Note:
How do you format a router?
How to reset your router to restore factory default settings
- Locate the Reset button on the back of your router.
- With the router powered on, use the pointed end of a paperclip or similar object to press and hold the Reset button for 15 seconds.
- Wait for the router to fully reset and power back on.
Is my dns-323 broken?
Is my DNS-323 broken? A common reason for the EasySearch Utility not being able to detect a DNS-323 device on thenetwork is due to a particular setting in Windows. Note: theinstructions below refer to Windows XP. The same settings can beapplied to Windows 2000 and Windows Vista, however the screens maydiffer from the screenshots below
Why can’t i Access D-Link dns-323 on Windows 10?
Time goes on and so do update all the systems we use – as much as any does Windows 10 and not so much – D-Link DNS-323 network storage disk system. This has caused, after a major Windows 10 update, the network share previously available on the D-Link nas, to become not available to access from the Windows 10 machine.
What is the default IP address for a dns-323 NAS?
DNS-323 will wait to be assigned an IP address via DHCP. If it does not receive a DHCP assigned IP address, by default it will boot up with a self-assigned IP address of 192.168.0.32. Once you are able to see the NAS I would also check the firmware as you will need the latest available(v1.08) to be able to use 2Tb drives.
What format type is the Dlink 323 hard drive?
From what I’ve read the Dlink 323 is Linux based so the format type is EXT2/EXT3 and I’ve tried formatting my 2 hard drives using GParted format softwarebut when I put them into my 323 and I run the Easy Search Utility it doesn’t detect my NAS?