Can cedar tongue and groove be used outside?
For interior, as well as exterior use, Western Red Cedar tongue and groove (T&G) paneling can be installed vertically, horizontally, or diagonally. It is commonly used as an exterior siding and cladding, in soffits and for ceilings, and either interior or exterior accent walls or paneling.
Do you use the rough or smooth side of cedar?
The best thing you can do is to approximate the color of new wood by putting on a cedar-tone stain. First, install the siding with the rough side out. A smooth surface holds less finish and weathers much quicker than a rough-sawn surface.
What is tongue and groove cedar used for?
Eastern White Cedar Tongue & Groove paneling is most commonly used for basic Exterior finishing applications because of it’s resistance to weathering, rot, and insects. Boards can also be used for carpentry, hobbies, furniture, shelving, and general finish work, with a warmer feel than many other species.
How much is cedar tongue and groove ceiling?
According to the material you choose it can run anywhere from $2.00-$3.50 per square foot. It comes in many different wood species like knotty pine, clear pine, cedar, and redwood.
How do you nail T&G cedar?
Each piece of Cedar T&G will need to be secured to solid wood with at least a 1-1/4” penetration approximately every 12”. Once the nailers are in place, use a level or plumb line to ensure the first board is installed plumb. As with horizontal installation, pieces up to 6 inches in width can be blind nailed.
Should I sand cedar before staining?
If your cedar deck is newly installed, you’ll need to sand* the cedar boards prior to staining. The boards go through a planing process at the mill that result in “mill glazing”. The planing process causes an oily surface on the boards that can hinder the wood stain from penetrating the wood.
Can I use tongue and groove outside?
Can you use tongue and groove flooring outside? Tongue and groove flooring can definitely be used outside. That being said, due to the way the pieces fit together, there will not be a lot of room to allow moisture through.
Should you seal a cedar ceiling?
The official recommendation from CedarSafe is no, you should not seal your cedar ceiling. Sealing it can cause the wood to warp, and is never recommended.
Are cedar ceilings expensive?
Cedar ceiling material by itself is not particularly cheap, and with the added cost of labor you could end up spending upwards of $2,500 on a single room’s ceiling.
Can I use a brad nailer for tongue and groove?
A finish nailer or brad nailer is the easiest and most efficient tool to use when installing your new shiplap or tongue and groove. They can be purchased/rented relatively cheaply from your local hardware store, they’re lightweight, and are simple enough that a 12 year old can use them!
Can I use tongue and groove on a deck?
The answer is yes. Creating a deck with tongue and groove lumber is as easy as creating a deck with traditional boards. First, cut all of your pieces into appropriate lengths. Next, coat any fresh cuts with an end sealer.
What is rough cut cedar used for?
Aside from building or remodeling parts of your home with this material, rough sawn lumber can be cut for other applications as well. The natural look makes these planks perfect for outdoor furniture like picnic tables and chairs or even swing sets.
How do you smooth rough cut cedar?
If you do need to sand it with a power sander, use an orbital sander with 100-grit sandpaper. Keep the sander moving, using circular motions to flatten and smooth the surface. Don’t allow the sander to remain in one place. When the surface is consistently smooth, stop sanding and proceed sanding by hand.
Should you caulk tongue groove siding?
The bottom of siding boards should not be caulked Water is meant to exit through the bottom of each board. While paint does tend to somewhat glue these pieces together, caulking them is never advised and can cause permanent damage. Also, avoid caulking tongue-and-groove siding boards together.