How do you turn on a spa quip?
Light Operation
- Short presses of the button activate the light functions as detailed above.
- Holding the button will begin to increase the set temperature of the spa.
- When a Spa Power Variable Speed Blower is fitted and is turned on the button increases the blower speed.
What does H20 mean on Spa?
a lack of water in the heater
H20 code (The spa has detected that there is a lack of water in the heater) 1. Check to make sure that the spa is filled with water to the correct level. 2. Press the pump button – The spa will attempt to run the pump for a few seconds to circulate water through the heater. Repeat if necessary.
What is SPA power?
Pump Mode button: The Spa Power 500 controls the water pump and heater automatically to maintain the water at the desired temperature. The user can leave the system to look after the pool and know it will be at the right temperature whenever he/she wishes to use it.
What does E3 mean on hot tub?
The E3 Error indicates a condition where the Temperature Sensor has sensed a high temperature (Greater than 113 F. / 45 C.)
What does Dr On a hot tub mean?
A message such as “dr” or “dry” or “heater dry” is a warning that there’s no water in the heater tube, says Niagara Hot Tubs. Although safety sensors are supposed to detect a dry condition and shut off the heater, be sure to manually disconnect power to the pump and heater before troubleshooting the unit.
What happens if no chlorine in hot tub?
When you don’t use chemicals in your hot tub or use too little, you are creating the perfect environment for algae, bacteria, and other contaminants to thrive. Attempting to use your hot tub without chemicals could leave your water green or cloudy, as the water temperature is the ideal range for contaminants to grow.
What does H20 mean on a spa?
H20 code (The spa has detected that there is a lack of water in the heater) 1. Check to make sure that the spa is filled with water to the correct level. 2. Press the pump button – The spa will attempt to run the pump for a few seconds to circulate water through the heater. Repeat if necessary.
How do you fix error 8 on a spa?
E08
- Turn Pump On.
- Press Test – either on the PRCD or on the pump screen display.
- Turn plug off and remove from socket.
- Plug back in and turn on.
- On the PRCD (black box) press: Reset → Test → Reset.
- Hold down the On / Off button on the pump for 5 seconds.
What does E1 mean on a hot tub?
The E1 Error Code has been implemented to indicate when the Portable Control Unit (PCU) senses a fault with the temperature sensors. This fault may be a worn sensor, corroded connection or wiring.
How do I adjust the temperature on the spa power 600ac/bc?
The Spa Power 600AC/BC gives the user direct control of the pool temperature from the poolside control panel. Holding down the Up or Down button will adjust the temperature set point as shown on the digital readout. There is a slight delay before the buttons operate to reduce the risk of accidental adjustment.
What type of pump does the spa power 600ac/bc use?
The Spa Power 600AC/BC uses a small circulation pump which runs 24 hours a day, to circulate water through the filter and heater.
How do I adjust the blower speed on my spa power?
If a Spa Power Variable-Speed Blower is fitted, the spa user has the ability to adjust the blower speed to any desired setting. The Up and Down buttons are used to set the desired blower speed.