Where is the Learn button on Minn Kota Riptide?

Where is the Learn button on Minn Kota Riptide?

Push and hold the learn button located on the top of the Motor Control Head. A steady audio tone will be heard while holding this button. 3. While continuing to hold the learn button down press and release any button on the remote being programmed.

How do you turn on a trolling motor?

Depress either the “Constant” or “Momentary” control switches on the foot controls, usually placed on the sides or ends. These can be depressed by simply pressing them in with the end of your shoe or toe. This action will cause the trolling motor to turn on and begin moving the boat.

How do I connect my phone to Minn Kota?

Download the i-Pilot Link app from the iOS or Android app store. On the device you intend to pair with the i-Pilot Link controller, turn Bluetooth “on”. Locate the Pair button on the top of your Control Head. The Control Head contains the i-Pilot Link controller.

How do you unlock the Minn Kota I pilot remote?

Pressing and holding the Screen Navigation button also locks and unlocks the remote.

How do I turn on Minn Kota i-Pilot?

Press to enable AutoPilot. Press to increase or decrease motor speed. Pressing this button will turn the Prop on and off. Press to steer the motor to the left or to the right.

How do I learn Minn Kota remote?

Push and hold the learn button down (learn button is located at the top of the remote). A steady audio tone will be heard while holding this button. While holding the learn button on the controller, push any button on the remote. Three short chirps will be heard when the remote is successfully learned.

How do I connect my Minn Kota trolling motor to my phone?

To do this on an Android device, launch the Raptor app, and follow the on-screen setup guide instructions.

  1. The app will ask you if you’re setting up for one or two Raptors.
  2. Once this is complete, or if you’re only pairing a single Raptor to your Android device, then select Bluetooth Settings.

What is the Learn button on I-pilot remote?

Does Minn Kota Riptide have spot lock?

Spot-Lock is available on select Riptide Terrova, Riptide PowerDrive and Riptide Ulterra trolling motors.

How to install Minn Kota Power Drive trolling motor?

TROLLING MOTOR INSTALL & RIGGING DIAGRAMS. Diagrams outlining the accessories and cables required to connect a trolling motor to a 12v, 24v, 36v, or 48v system. TROLLING MOTOR INSTALL/WIRING DIAGRAMS.

How to disassemble a Minn Kota?

An open space

  • Fuel should be nil
  • Discharged battery
  • Rigid platform to place the motor
  • Appropriate tools
  • A torch
  • A dry cloth
  • Some lubricant
  • How fast does a Minn Kota trolling motor go?

    how fast will a minn kota trolling motor model 35 24 lb thrust trolling motor go on an 14′ aluminum boat at full speed?|||Take your pick… It will do about 2 mph for 7 hours, or 7 mph for 2 hours.

    How to replace a Minn Kota trolling motor prop?

    The composite shaft requires periodic cleaning and lubrication for proper retraction and deployment.

  • The propeller must be inspected and cleaned from weeds and fishing lines after every use.
  • Verify the prop nut is secure each time the motor is used.