How do you use Prosaid?
Use cotton swabs to apply Pros-Aide to the skin and to the appliances to be adhered. Allow to slightly dry, and press the objects onto the skin. If required, slightly lift the edges, apply more adhesive, and press them into place.
What is prosthetic transfer method?
Bondo transfers, also known as Prosthetics transfers or even 3D Transfers, are an acrylic based material that when scrapped into addition cure flat plate mould allows you to transfer it directly to skin. This can be a cut, scar, wound or even swallow eye bags, it’s completely limitless and incredibly easy to use.
What are Tinsley Transfers made of?
Tinsley FX Transfers – SMALL GOUGE – (we sell the best pulls only!) 100% LATEX FREE! Applies Like A Temporary Tattoo. Activate With Water.
How long does it take for Pros-Aide to dry?
It provides a strong, long lasting, water (and sweat) resistant bond. To use, apply to clean skin and the prosthetic, wait until product becomes clear and tacky (about 10 minutes, although you can use a hair dryer to speed things along).
Can you reuse silicone prosthetics?
Because it is completely reusable and quite a bit more durable, as well as easy to repair. The only drawback to silicone is its cost.
What is pro Bondo?
Well, Pro Bondo goes by many names including Prosthetic Transfers, Pros Aide Transfer, 3D Transfers or simply Bondo. Whatever name you like to use, the product stays the same: an acrylic adhesive based material used with translucent flat plate transfer mould to create cuts, scars, eye bags and even aging pieces.
How do I remove a Tinsley transfer?
Tinsley FX Makeup can be removed by washing off with soap and water or with any makeup remover without any staining on skin. Note: Please follow the instructions closely, as handling without proper care can damage the transfer, making it unfit for use.
What is the strongest skin adhesive?
Silicone adhesive: One of the strongest skin-safe adhesives available. Water-resistant and incredibly strong; silicone adhesives are compatible with most appliances and is typically used in film and TV.
How do you remove adhesive from Pros-Aide?
Pros-aide can be a little more stubborn, so you would need some oils for that. The best product to remove it with is BOND OFF. Isopropyl Myrestate is a good one too, but takes longer. To remove like a pro, use BOND OFF and a small brush and start on one edge and gently work your way around the whole piece.
Can you use Pros-Aide on silicone prosthetics?
Silicone prosthetics are not attachable using spirit gum. We offer 2 adhesives, Skin Tite and Pros Aide. We recommend Pros Aide over Skin Tite, as Skin Tite requires more prep work, and even with a good cleaning of the skin with alcohol, sometimes it just doesn’t cure because of a reaction with your skin.
How long does Pros-Aide take to dry?
How long does pro Bondo take to dry?
To be on the safe side, we recommend leaving it to cure overnight. If you want to speed up the process, you can pop it in a dehumidifier.
How do I uninstall Probondo?
REMOVAL: To remove Probondo pieces, use Remove-It-Gel I or II, or Ad-Clean. Apply a little to the edge of the piece and using a brush work under the piece, lifting as you go. Remove the piece and clean the area with more Remove-It or Ad-Clean. Wash the area thoroughly with warm soapy water.