What is the proper height for guitar pickups?
We recommend between somewhere close to 5/64″ on the bridge pickup, and about 4/64″ on the neck. Keep in mind, these are measurements on the Low-E side. On the High-E, we might suggest you move it just a tad closer (say 1/64″ on each pickup). Adjusting height is easy.
Are Lollar Pickups RWRP?
The pickup is only RWRP relative to the other pickup(s) it is being matched with. This will make a combination when both pickups are used at once that will minimize 60 cycle hum.
How high should the pickups be on an electric guitar?
Remember, this is just a guideline. What should be the determining factor for your guitar’s pickup height is what sounds preferable to your playing style. Start by setting all of your guitar pickups to 3/32” (0.093”, 2.38mm) on the bass side and 2/32” (1/16”, 0.0625”, 1.98mm) on the treble side.
What is the best pickup height for humbuckers?
For standard, full-size humbuckers, a reasonable starting point for the bridge pickup is at least 1/16″ (1.5mm) from the high E and 5/64″ (2 mm) from the low E. There are no recommended distances for the other 4 strings.
How close should P90 be to strings?
The truth is that you might find the tone you are looking for anywhere from the closest you can get those puppies to the strings all the way to as far as you can get them away from the strings (about 6-7mm is as far as you can go on a Les Paul style guitar).
Why choose Lollar Pickups?
Furthermore, Lollar pickups are potted just enough so you can actually tweak the amount of microphonics you get with spring tension. Our method of coil tensioning and potting ensures that your pickups will not become loose over time, so you can be sure the way it sounds today will be the same 20 years from now.
What is the Imperial® humbucker?
The Imperial® Humbucker captures the airy top end, balanced midrange, tight lows, and complex overtones of the classic original P.A.F. pickups. We then improved on the design to give you a more balanced frequency response.
What is the Lollar special s bridge position pickup?
This bridge position pickup is a very slight variation on the Lollar Special S ® series bridge. For “off the shelf” ordering, you would want to order the Lollar Blondes for the neck and middle, and the Lollar Special S for the bridge.
How are Lollar pickups wound and potted?
Every Lollar pickup is wound with a specific amount of tension for a tight coil, and then potted, based on the particular model and what has been found to be the optimum balance of effective isolation and good “vibe”. Furthermore, Lollar pickups are potted just enough so you can actually tweak the amount of microphonics you get with spring tension.