Where should the axle of a 14 foot trailer be?
For example, if the trailers frames length is 14 feet, then the center-line location for the equalizer hanger will be 8.4 feet from the front of the trailer and 5.6. feet from the back. This is where to start with when picking out axle locations for a tandem axle trailer.
How much clearance should a trailer have?
As a general rule, when your trailer is loaded to it’s full capacity, there should be a minimum clearance of 3 inches between the top of your tire and the underside of your fender. This should give you adequate clearance for potholes and bumps.
What is the maximum length your tandems Cannot exceed?
The load upon any combination of vehicles shall not exceed 75 feet. 35414.
How much clearance do you need between gender and trailer tires?
Expert Reply: To have enough clearance for the trailer to travel over bumps in the road you want to have at least 3 to 4 inches between the tire tread and the fenders as well as 1 to 2 inches between the side wall and inside of the wheel well.
Why do shippers make you slide your tandems?
By sliding the trailer tandems forward, you will put more weight on the trailer tandems and take weight off the tractor’s drive axles. Conversely, by sliding the trailer tandems toward the rear of the trailer, you will take weight off the trailer tandems and put more weight onto the tractor’s drive axles.
How far should the axle be from the back of trailer?
That should position the rear axle about eight-10 feet from the back of the trailer — and keep you under the maximum allowable kingpin-to-tandem distance in most states and Canada. Most trailers weigh about the same, but they many use four-inch or six-inch holes in the slider.
What is a drop axle on a trailer?
A Drop Axle just allows the trailer to sit lower, usually 4″ for a leaf spring style. Torsion style trailer axles handle the drop a little different. A rise or drop happens by setting the no-load Arm Start Angle. When that angle is ‘UP’, then it accomplishes a small “drop”.
What does mounting position mean on a trailer?
For this discussion, Mounting Position means the measured location where axle connects to the trailer frame. For Leaf Springs it’s the Spring Centers distance. That defines the mounting. For positioning the axle fore and aft on the trailer, the article on Calculating Axle Position may interest.
What are trailerlegs and how do they work?
Trailer tires spend all their lives sitting on the ground with weight pushing down on them, which is why most trailer tires fail prematurely! Give your trailer tires a much needed rest by lifting and supporting them off the ground with TrailerLegs! Designed to lift most trailers up off of their tires by using a tow vehicle to push or pull!