How do I reset Powrtouch?
first make sure the rollers are disconnected from the tyres. remove 4 screws an the black cover and locate the setting button . press this setting button the red LED light will start flashing then switch on the hand set by simultaneously pressing and holding down the two red buttons (marked on) .
How long does it take to fit a motor mover?
Fitting a mover to a single axle caravan takes about 1 to 1½ hours. Fitting all wheel drive models to twin axle vans takes about 2 to 3 hours.
How long does it take to fit a motor mover to a caravan?
Why is my motor mover remote not working?
Motor Mover Remote / Handset Batteries Are Dead Now in most cases once the leisure battery is charged or the remote has batteries that are charged your motor mover will be operational again however, there may be some underlining issues if this isn’t the case.
How do you remove a Powrtouch motor?
Separating The Top Section / Replacing The Motor Remove the side cover. c) You will now be able to remove the old motor and replace it with the new motor. Remove motor gear off the old motor by removing the allen key screw and refit to new motor.
Is a twin axle caravan easier to tow?
While towing that wider pivot point on a twin axle provides more stable towing performance, its a hindrance when it comes to manoeuvrability. Now many caravanners today choose to have a motor mover fitted. Its just simply so much easier to steer your caravan with a remote control than trying to reverse a caravan.
Where can the powrtouch classic be fitted?
Wherever the Powrtouch Classic is fitted this should be done in accordance with the local standards applicable to the installation of a remote-controlled caravan moving system. Truma Limited Powrtouch –a Truma brand 2000 Park Lane, Dove Valley Park, Foston, South Derbyshire, DE65 5BG United Kingdom
How do I use the powrtouch classic wrench?
On the Powrtouch Classic models the start position for the wrench should be as low as possible to the ground with the handle pointing away from the rollers. Always take great care with this operation as the over locking cam system together with its return spring require some force to move the rollers into position against the tyres.
What type of battery does the powrtouch classic use?
• The 12volt leisure battery MUST be fully charged and in good condition to enable the Powrtouch Classic to operate to its full performance specification – to check your battery see Section 5 Paragraph 5.4 of this instruction manual. • The handset is powered by a 9volt DC battery (PP3 or equivalent).
How do I fit the powrtouch Classic side covers?
Check the roller rotation corresponds to the handset controls. Any hole(s) drilled for motor wires to access the caravan should now be sealed with the silicon sealant to prevent ingress of damp or water. The Powrtouch Classic side covers can now be fitted by securely pushing into place.