How do I reset my Mt Vernon pellet stove?
To reset the Mt. Vernon stove or insert, WHEN IT IS NOT RUNNING, unplug the stove for 60 seconds, then plug it back in.
Why is my auger not turning in my pellet stove?
If the auger is no longer turning, chances are that it is experiencing a motor failure, pressure switch failure, or that it is clogged from pellets and debris. The best thing to do is to first unplug the stove and open up the compartment to test the motor and then clean it out completely.
Where is model number on Quadra-fire?
Each fireplace has a rating plate either inside the operating door or in the lower controls cavity. On that rating plate is your model number and serial number.
Is Quadrafire a good pellet stove?
“We had a Quadra-Fire Mt. Vernon pellet insert put into our existing fireplace. It’s a great heat source – just set the thermostat and add pellets once a day. It’s easy to clean, keeps the house toasty and has a battery backup if we lose power.”
How do you test a thermocouple on a Quadra Fire pellet stove?
The simplest way to test a thermocouple is to check how much voltage it produces. To complete this test, you will need a digital meter that can measure millivolts (mV) of DC electricity and a lighter. Remember to unplug the stove from the wall before disconnecting any wires.
Should you be able to turn a pellet stove auger by hand?
Attempt to manually turn the motor output shaft when disconnected from the power. The shaft shouldn’t be able to move. A pellet stove auger motor shaft that can be rotated manually or can be stopped manually when operating can be a sign that the gears inside the motor are worn and the motor needs replacing.
How many amps does a Quadra fire stove make?
115 VAC, 60 Hz, Start 4.1 Amps, Run 1.1 Amps *BTU output will vary, depending on the brand of fuel you use in your stove. Consult your Quadra-Fire dealer for best results.
Where can I find information about the Mount Vernon pellet stove?
Mt. Vernon Pellet Stove IMPORTANT: THIS IS DATED INFORMATION. The most current information is located on the Quadra- Fire web site at www.quadrafire.com.
Where is the insert on a pellet stove?
Pellet Stoves & Inserts: Behind the side curtain or access panel; on the outside of the hopper; or on the inside of the hopper. Gas & Wood Inserts: In the control compartment either on the side of the firebox or under the ash lip.
How do you adjust the fuel on a Mt Vernon pellet stove?
Mt. Vernon Pellet Stove Set Screw Thumb Screw Increase Decrease D. Fuel Adjustment Rod The set screw is located at the bottom of the hopper and set loose at the factory so the fuel adjustment control rod will slide up and down by only loosening the thumb screw at the top.