What does LL mean on my atomic clock?
too low
Oregon Scientific weather stations, thermometers, weather forecasters, atomic clocks with temperature indicate the temperature or humidity reading is out of range by displaying LL. L (too low) or HH. H (too high).
How do I manually set my lacrosse atomic clock?
Press and hold the SET button for 3+ seconds to activate the manual mode. Once the clock is in manual mode, there are two ways to move the minute hand forward. 2. Hold the SET button down to move the minute hand forward consistently.
How do I reset my Sio scan atomic clock?
Insert the three AA batteries into the back. Make sure to use the plus and minus symbols to ensure the correct polarity of the batteries. Replace the battery cover onto the back of the weather station. Press the “Reset” button to restart the clock of the weather station.
How do I reset my La Crosse Technology clock?
How to Reset the Time on a LaCrosse Weather Station
- Turn the LaCrosse Weather Station over, remove the device’s battery cover and batteries from the unit.
- Press and hold the “Set” button on the unit for five seconds.
- Complete steps 1 through 3 in the “Resetting The Time Using Radio Controlled Time (RCC)” section above.
How do you reset a LaCrosse technology atomic clock?
Hold the WAVE button down for 3+ seconds. The hands will automatically reset to the 12:00 position, and the clock will search for the WWVB time signal. If the clock receives the signal, the clock will set automatically to the correct time.
How do I reset my atomic radio controlled clock?
Atomic Clocks may also be set manually and be very accurate. Simply insert the battery, press your time zone and then press the flap just above the left side of the battery. Hold until you reach the correct time and then release.
How do you reset the outside temperature on an atomic clock?
Once the sensor is reading to your clock, place it outside in a shaded location. Hold the SET button to enter the Settings Menu. Press the PLUS button to adjust values. Press the SET button to confirm and move to the next item or exit.