Table of Contents
How do I change the code on my Weiser door lock?
Press and HOLD the Program button while reinserting the battery pack. Keep holding the button for 30 seconds until the lock beeps and the status LED ashes red. Press the Program button once more. In 20 seconds, when the LED ashes green and you hear one beep, the lock has been reset.
Why is my Weiser lock not working?
If you lose the functioning key(s), you would need to either take the SmartKey lock back to the home improvement retailer or an authorized Weiser locksmith to reset the lock, just as you would with any conventional lock. Once reset, SmartKey will function normally.
How do you reset the code on a Weiser deadbolt?
Weiser Lock reset: Hold the program button for 30 seconds until the status LED flashes red. Press the program button again. The lock has been reset when the LED flashes green. Verify the lock has been reset by pressing the lock button while the door is open.
How do you Program a Weiser deadbolt?
Note: Programming instructions can also be found on interior of lock.
- a. Press the program button on the interior unit once.
- b. Enter in 4 to 8 digit code onto the keypad.
- c. Press the “LOCK” button to save code.
- d.
- a. Press the program button on the interior unit twice.
- b.
- c.
- d.
Why is my Weiser lock flashing green?
Low battery. Replace batteries. Keypad flashes green with continuous beeping sound for two seconds.
Why is my Weiser lock flashing yellow?
Prior to the battery dying, the interior LED will flash yellow/red or green/red. In addition, the exterior keypad flashes red and the lock beeps for about 3 seconds upon code entry to notify the user far in advance to change the batteries.
How do I reset my digital lock?
How do I reset my padlock?
- Pull up the shackle to open the lock.
- Rotate the shackle 90° counterclockwise and press all the way down.
- Hold down the shackle and set your own combination by turning dials.
- Turn the shackle back as normal. The setting is now complete.
Why is my door lock blinking red?
The Schlage button flashes red continuously. What does this mean? The battery is dead. You will need to replace the battery immediately.
Why is my door keypad blinking red?
If your Electronic Door Lock is beeping and the buttons are flashing red, this means that there’s been some kind of error or the batteries are low. If the batteries have already been changed and you still see a red flashing light when you try to use the lock, there could be an error with the lock.