Table of Contents
How do I configure my TP-link router as an access point?
How to change a TP-Link router to AP mode
- Connect a computer to the TP-Link router and launch a web browser.
- Visit the following router configuration page: 192.168.1.1.
- You are prompted to enter a username and password.
- Click the Mode button on the upper-right corner, select Access Point and click Save.
What is the default IP for TP-Link access point?
192.168.1.1
Normally your TP-Link Router’s default IP address is http://192.168.0.1 or http://192.168.1.1.
How do I access my TP Link wireless access point?
Open the web browser and type the IP address of the access point/extender (Default is 192.168. 1.1/192.168. 1.254/192.168. 0.254) into the address bar and then Press Enter.
How do I change my access point name TP Link?
Go to Wireless -> Wireless Settings and configure the SSID (Network name). Select Save.
What is the difference between access point and router mode?
AP mode allows you to extend the reach of your wireless signal by acting as a relay with a few simple software changes. Using AP mode supports a single, wide-reaching network with multiple routers sharing one password, while router mode creates individual, self-contained networks.
Does a wireless access point have an IP address?
Wifi access points need not have an IP address, any more than wired switches and hubs do. However a large number do, as they also act on the IP layer as DHCP servers and network gateways.
How does WIFI Access Point work?
Access points work by connecting direct to your broadband router or network switch with a Ethernet or data cable. This provides the AP with the internet connection and bandwidth required. It then transmits and receives a wireless signal in either the 2.4Ghz or 5Ghz frequency range (WIFI).
What is TP-Link tl-wa901nd access point?
The TP-LINK Wireless N Access Point TL-WA901ND is designed to establish or expand a scalable high-speed wireless N network or to connect multiple Ethernet enabled devices such as game consoles, digital media adapters, printers, or network attached storage devices to a wireless network.
What is the firmware for tl-wa901nd (US) V5?
1. For TL-WA901ND (US) V5. To Use Third Party Firmware In TP-Link Products. Some official firmware of TP-Link products can be replaced by the third party firmware such as DD-WRT. TP-Link is not obligated to provide any maintenance or support for it, and does not guarantee the performance and stability of third party firmware.
How is the tl-wa901nd powered?
The TL-WA901ND is able to be powered using an Ethernet cable to simultaneously send data and electricity to wherever your AP may be located even up to 100 feet away.
Can I use third party firmware on my TP-Link product?
Some official firmware of TP-Link products can be replaced by the third party firmware such as DD-WRT. TP-Link is not obligated to provide any maintenance or support for it, and does not guarantee the performance and stability of third party firmware. Damage to the product as a result of using third party firmware will void the product’s warranty.