How do I change the code on my Sentry Safe x055?
1 Open the safe’s door and remove the battery compartment cover. 2 Locate the button inside the battery compartment and press. The yellow LED light will go on. 3 Enter a new user code (between 2-8 digits) followed by the “#” key.
What is my Sentry Safe factory code?
The Sentry Safe products have three codes associated with the lock. Factory Code: The Factory Code is a five-digit code located on the back of your manual. It is to be noted that a factory code can never be deleted or changed and will always open your safe.
How do you get into a Sentry Safe if you forgot the combination?
How To Break Into A Sentry Safe | Helpful Legal Hacks
- Contact Sentry Safe for assistance or call them at 800-828-1438. (Best for safes over $100.)
- Call a local locksmith.
- Use a high powered magnet to trip the lock.
- Use a nail file.
- Use a paper clip.
- Other destructive means like using a drill.
What do you do if you forget your Sentry Safe combination?
You must call (800) 828-1438 for combination retreivals. The following is for informational purposes only: If you need your combination, you must send a notarized letter stating you are the owner of the safe. (Note: the owner’s last name must be different from that of the notary public).
What do you do when a sentry safe won’t open?
Turn your back to the safe, and kick the door, hard, a few times. Be sure that you do not kick the keypad or the handle. This will help loosen the bolt work. Next, pull the handle in the opposite direction than you normally do and enter the code.
What do I do if my Sentry lock is not working?
Replace the existing batteries with new ones. (See “changing your batteries” in troubleshooting) If the lock still does not open, contact Sentry Group Customer Care: 1-800-828-1438 or 585-381-4900 (Available Mon – Fri, 8:00 am – 6:00 pm EST).
How do you drill a hole in a 4 bolt safe?
Position the safe in the desired location. From inside the safe mark the location of the four (4) bolt down holes. Move the safe aside to the clear marked spots for drilling. Using the ½ in. masonry drill, drill a 4 in. deep hole in the marked locations.
How do you fix a locked safe that wont open?
Pass each masonry anchor through the safe floor into the drilled holes; making contact with the safe floor. Tighten each masonry anchor with the adjustable wrench. Replace safe floor carpet. The green LED light will signal in red when opening your safe. The lock is giving you a valid signal but is not unlocking.
How do I open the safe with two people inside?
When you want two people to open the safe; set your safe to dual user mode. One person enters their code and within sixty (60) seconds, the second code is entered. Always perform this operation with the door open.